Search results

Costs a bit to install though, which would be a waste if it was never used. I guess I was hoping for someone here to sway me one direction or the other.

Question; is electric underfloor, i.e. a Devimat, completely OTT to put into a tiled floor bathroom when it will already have a convection radiator in there anyway? The radiator will certainly heat the bathroom properly but will it take the chill from the tiles on the floor sufficiently during...

Thanks for the reply. Homeseer support lots of different alarm systems mostly via third party drivers. Also the support is very much community/forum driven for what its worth. Also they sell DSC panels via their website so they would probably recommend them as they've partnered with them -...

Ooops, sorry :-) I don't mind the pump coming on for just the hot taps & shower. Regarding the shower - is it likely that any shower that says compatible with combi boiler would be suitable, like this one

Plumber tested it and said it was quite low - sorry I don't have the psi/bar figures. Also I don't think you are allowed to put a pump on the mains supply (in Ireland). Even it was possible I don't think I'd want a pump coming on anytime water is used in the house due to the noise

Hi there, Looking for some advice about installing a replacement alarm system. I've installed several DSC PC1832 panels in the past - with wired and wireless sensors. The panel does work but it is a pain to configure, also I've found the wireless sensors to sometimes be a little bit...

Hi there, Currently getting a house refurbished (and properly insulated) with a new CH system. Have very basic hot water requirements (there's a Triton electric shower there already) so was going use a combi boiler and get rid of the old hot water cylinder to get a little bit more storage...

Thanks for the reply I guess not. I posted the link to the wrong manual - I meant to link to this one Ok - can you elaborate a bit more. All of the other z-wave devices are in and working - all the other switches and dimmers were 2-wire so they were simple swaps. It's just this last...

Hi there, I currently have a dual dimmer switch which is wired as two separate single pole switches. For each light circuit I have just two wires into two separate dimmer modules. I want to replace this with another dual dimmer switch which supports home automation (z-wave) and unfortunately...