Search results

Hi, Purchased a Friedland D525 door chime in the end. States 8v on box and instructions. Sticker on back shows 8v/12v. I already have a 12v Friedland C75 transformer wired up from the old door bell (see above posts), so would like to know if I can re-use this? Although interestingly...

Cheers everyone. If I wanted to buy this door chime. How would I map over my existing wires please? http://media.chbyron.eu/file/pdf/1346168183-7721manual.pdf I have two push buttons, not sure this chime accommodates two

Thanks. So, on a new chime what would the old connections R map to. 0 map to. 2 map to. I'm not sure which wire is which?

Hi, Please ignore the coloured insulating tape, I added that before I removed the doorbell so I can recall what wire went where. I am looking to replace this door chime with a more modern one due to the presence of a Mercury Switch. I am not clear what the terminals "R" "2" "0" actually...

No need to turn mains and/or disconnect battery??

Hi again, Just won a 9827 KeyPad on Ebay for £35 inc delivery. Does anyone know the (baby) steps I need to follow to remove my old 9800 keypad and replace with this one. I can't see any screws etc on the existing keypad, does it just 'prise' off the backplate?> I do NOT have the...

Good point, the one I removed was an Ultracell 2.4 amp hour dated Dec 2006 in black marker pen on the side.. lasted well

Hi, Any chance you might have a pdf copy of a Scantronic 9800 Engineers Installation Manual? If so a copy would be much appreciated. Cheers Kevin

Hi, Scantronic 9800. I have the Bf fault code. So have removed the old Panel Backup battery which was an Ultracell UL2.4-12 (2.4 Amp Hour/20 hours). It seems a popular choice for Alarm Panels is the 'Yuasa NP7-12', a larger battery but one that is 7 amp hours. This will fit inside the...

I was taking up a laminate floor, and most of the under boards were the standard type, but it looks like whoever laid it ran out of the green laminate under boards and used this for a small section. Any ideas what it is. Has the letters ACC or could be ACO printed on it.

Cheers. Copper pips is good and straight. I cleaned up with wire wool which mixed with water as I was doing it due to the pipe being low down and dripping a bit. I then wiped with a damp cloth. The fitting is in place as I type and is sound and watertight. What concerns me is...

Hi, I used some speedfit the other day. I had to make a connection to the existing copper pipework. I cleaned with wire wool the green staining and other muck for a couple of inches at the end of the pipe where I pushed the Speedfit connector. I've just realised the green staining...

Hi, Put the Washing Machine on a programme today, then there was a popping sound (like a tin falling from a cupboard) followed by a slight smell. After this the washing machine programme dial just clicked round fairly fast whilst making a funny clicking noise. Now, I've been playing...