Search results

depending on how old and able can can fit a low profile bath with hand rails on the bath and walls remember people always fit rails at a 45 degree angle as this gives them better grip and ables them to put both hands on the rail and pull up better i have spent 4 years fitting bathrooms for all...

might be a bit late but its not the stop tap its water hammer and it will be debris in the valve its self take it apart and clean it :)

at this moment in time i have the owner down there who is my father in law to be lol he has turned the immersion off and is looking at it in a bit and giving me a ring i only went there to help him out my little 1995 astra van can get down there on £20 of fuel so its cheaper for him if he pays...

it is a fortic cylinder with a immersion heater thats it no boiler its only for hot water the house is a holiday cottage with storage heaters, the feed/vent pipe as it does the same job in this cylinder , if you put your hand in the header tank you can feel the warm water coming up the pipe and...

a grinder should but you need a good disc for it i advise hammer and chisel if its only a few hit the top of the block once then flip the block over and hit the bottom then the sides they normally break easy i have recently block paved my drive which had loads of cuts and i used a hammer and...

would you say lowering the ball valve in the header tank would solve this problem

my father in law to be is a window fitter has been for 20 years or so and if you can see a dimple in the window it shouldnt be there sometimes if you look side on at a window it can look like the glass has a curve but thats normal

the ball valve seems to be fine i am thinking the water level may be set to high in the tank and the expansion is sending the water out of the overflow but why is it happening now and not before?

it is only really pumping a kitchen tap and a bathroom tap as everything else is electric showers etc, i dont think it has anything to do with the pump its like the hot water is expanding more that it did before i know it sounds weird lol some1 said it could be that mains water is passing a tap...

i have fitted a pump to the 22mm hot pipe coming from the tank but since doing this when the hot water is heated up the vent pipe overflows and lets hot water into the cold tank then this fills the cold tank and that overflows to outside i dont think its the pump that is the problem... no cold...

hi people im new here, i have fitted a shower pump to pump the hot water in a house the shower pump is a whole house pump and is working fine the problem i have is the cold water tank on top of the cylinder( fortic tank) is getting warm water in it and then overflowing, would you say i needed a...