Search results

Cleaned it up!

Ok will try this and get back. Thanks!

It actually does look like a separate nut, I will try cleaning it a bit more tomorrow. How do I get to the packing? I am guessing I could have a go at applying ptfe after unscrewing it?

Thanks, tried elbow grease but not much black stuff coming off. Attaching pictures from different angles.

I have a heat only condensing boiler on the ground floor attached to a water cylinder. It is pressurized and I have been re pressurizing it when the pressure drops. This towel rail is on the first floor bathroom. There is another towel rail in the same bathroom which is physically located lower...

Thank you. Do you suggest swapping the whole unit (chrome part as well) or is it possible to change just the brass valve? Also is it something I can do it would you suggest a plumber.

Please see attached. Also, I put that ptfe there it wasn't there earlier.

To update, I managed to change the bleed valve successfully and it's not leaking anymore. However, now I found that the bottom right still has a tiny leak. Picture attached. I am guessing the valve needs replacing. Could you guide me on replacing / tightening this. Thanks

Thank you, will try this.

It screws down, so may be it was just a drip and I should keep going? It felt like it was getting looser rather than getting tighter. This is while rotating clockwise. When I go anti clockwise it tightens.

Thanks all for your help. I have a very basic question. How do I turn off both valves. The one on the right is easy as its the actual valve. The one on the left had a blank which i removed. There I can see a flat screw head. When i tried to tighten this clockwise it just pushed right in and...

I tightened that, and then found that there is a leak at the top of the rail as well. See picture, any suggestions for the top? Thanks

Yes it's exactly from there. Thanks will try this first.

I have found that my towel rail is leaking, not from the valve but from the nut where its attached to the rail. Picture attached. If i unscrew apply PTFE and screw back will that work? Will there be a lot of water? Not keen on draining the whole house down. Thanks!

Hi Could someone advise if there are any 2 star rated door plates that can hold a half cylinder from inside and have a blank on the outside. Handles on both sides. Thanks!

Prob the way to go

If you get it with a chime then i believe you can add an sd card to increase storage

Thanks sent you a dm

Any thoughts on eufy vs tapo?

I want the system to be able to trigger a call to police or guard response if there is a break in while away. It should *hopefully* give the intruders less time to be in the property and they know that a response team is notified/on the way.