Search results

doh... was being thick... flu and alcohol never mix..

isnt it that you can fill conduit up to 40% Or is it 60%?

why does it become live, do you isolate it to do the loop test?

9 cables in 20mm :o

id just buy a normal split load, and ask wholesaler to swap 100a non rcd for a 100ma rcd... or just buy the 100ma on its own.

1) Depends on Installation, but use 16mm 2) Current Regs 10mm 3) Its dependant on the regs the installation was installed to. 4) I would cross bond every pipe under the boiler, just to be sure. I use 10mm for this as I normally have plenty :D David

inspections for internal corners.. Circulars for when on the wall running down.. IYSWIM.. David

if its 2 cables and 4 wires.. then it should be Red from one cable to com and the corresponding black to L1 and the same on the other dimmer.. and Connect the earth.. if you connect both to L1 and L2 nothing will happen.. David

B-A-S.. Nice.. I had 130w.. E approved bulbs? Of course.. cough cough... Would love to change to HID's but price prohibits at the moment, as it doesnt make it go quicker :D david

AdamW... I had 137db before i pulled it all out.. bought a subaru instead and now me priorities are making it go quick! I had a 170A circuit breaker next to battery.. and could pulll well over 100A when having it fairly loud.. :D And despite what people might think it was set up more...

I used a battery connector used on forklift trucks / boats for my amps. David

We use them for all our server cabinets at work. We usually have each phase under each floor tile.. (so a row of three under each cab) we use 32a ones with a 20A breaker normally, but someone did fit some 16a ones.. We also use the three phase ones for some bigger cabinets. Its a shame...

deep cycle should be fine to flatten and then charge.. but two years? how many volts is it? and how many across terminals at moment? what sort of charger are you using? David

any multimeter that uses no current to measure a voltage is usless.. Our AVo model 8 isnt like that.. isnt much use for electronics / logic stuff though.. where as the fluke 4digit true rms jobbie is.. (cant remember the name) No substitute for a set of test lamps.. (cyclim - ours are...

A set of test lamps would be my choce...

I personally wouldnt use 2.5mm but thats up to you.. 10mm is the best idea, but its going to be hard without a 45mm patress.. the bigger the cable the better imho. David

would their be any disadvantage to having an RCD protect both ends? or does this really **** up discrimination?? David

Id also condem the showers until rectified.. a small shock when wet = dead

I was originally considering them but I deemed them unsuitable I was using the mv/a/m from pirelli as well Pvc is rated at 65 where as XLPE is 85 -90degrees iirc. David

what price do you do 3 core 16mm and 2 core 16mm for? David