Search results

50mm screws or 65mm ring shank nails ? http://www.screwfix.com/p/turbogold-countersunk-screws-5-x-50mm-pack-of-200/18950 or http://www.screwfix.com/p/turbogold-countersunk-screws-4-x-50mm-pack-of-200/12110

for 5m x 5m roof, screws would take some time to screw.

Which fixing to use when fitting OSB roof boards to joists. Nails or Screws ?

The flat roof will have brick wall on two sides, and rear of the flat roof will be against the main building at gutter level.

Is there a need for expansion gaps around the perimeter edge, when laying OSB roofing boards over the roof joist ?

What thickness celotex should I use for a warm flat roof.

Ouch that hurt !!!!!!!!!!!

Thanks for the info. The cable was positioned above and just left of the socket. This was my doing some years ago, when I removed part of the wall and had to move the socket couple or 3 inches to the right. !!

Just hammered a small picture nail through socket cable. RCD TRIPPED CORRECTLY. Nail removed and electric supply restored. Removed wall plaster to reveal cable. small hole evident in the middle. should I open the outer sheath and apply electrical tape to inner cores, and outer sheath. Or...

Couple of years ago I moved both Hot and Cold water tanks, from inside the attic into the bathroom below. I now suffer from very poor hot water pressure to all hot water outlets in the Bungalow. The Hot Tank sits on the bathroom floor inside an airing cuboard. Would the pressure...

How and what size bolts to use when fitting a 120x50 C16 timber to the web section of a I beam. The C16 will be used to hang std Jiffy joist hangers.

Thanks for the reply. Would 50mm to nothing firrings give me an adequate fall.

New Proposed flat roof which spans 3700mm. Would 75mm to nothing furrings give the correct fall. If not what size

A few years ago I installed TileLOC Slate Effect flooring. http://www.diy.com/nav/decor/flooring/wood-laminate-flooring/laminate_flooring/-specificproducttype-tileloc_laminate_flooring/TileLOC-Random-Slate-Effect-4-Pack-1-8Sqm-9376690 Over the passed few years several very small chips /...

What type and size fixing do I require for UPVC French Doors with two side panels ?

What sort of hangers to use for 2 x 44 x 195 C16 joists bolted together. I think a face hanger bolted to the masonry wall, due to one course of engineering brick joist height. Would two of these be suitable http://www.wickes.co.uk/invt/214876[/wiki]

I am going to lay the boards 90 degree from the joist. Do I need to fit additional noggins to support the T&G short ends and long sides.

Just asked my local timber merchant for a quote 200x50mm timber joists. They quoted back C16 reg'd and graded carcassing 44 x 195. Would this reduced size ok for roof joists. If not what grade

Who sells 2.4 x 600 OSB3 T&G ? I can only find 2400x1220. Kettering Northamptonshire

Does anybody know what type & size hangers, are required for 200 x 50 mm flat roof joist. Timber to timber.