Search results

Good points, It was confusing because the problem started with occasionally displaying the "Check Inlet" Red Light and then stopping. If I restarted the program it would most likely be OK. I then checked the inlet water supply which is about 3 Bar and removed, cleaned and replaced the...

I have tried what you suggested. It appears to read around 4 ohms across two of the contacts until I apply the 12V. After this, the reading reverts back to start value of 1. Note, Black Omron G2RL-2 has 6 connections while RT114012 has 3 Black OMRON Relay 4 Ohms between connections 1 and...

No, I didn't, can you give me an idea of how you would make that check ? Thanks SMc

Hi All, I have a Miele W844 with a EL200C board fitted My machine keeps stopping during the cycle with a Red Flashing Light “Check Inlet” OR a Red flashing light “Check Drain”. This does not happen every time, maybe 50%. I have removed the EL200C board and checked the T 6,3A Fuse...

Two relays by the circular cut out are Black Omcron G2RL-2 and Orange SCHRACK RT114012

Images Of the Miele W844 Washing Machine.

Yep, looks like the CH motorised valve. The heating has been switched off for over 1 hour using the mains isolation switch, however, the underside of the motorised valve is still too hot to touch with my fingers !! Thanks, SMc

Hi, thanks for that tip, would that be the Central Heating Motorised Valve (Only 6 months old!) or could it also be the Water Motorised Valve ? SMc

Hi, The System is standard unvented with a Turkington Engineering Turco 2000 Outdoor System 70/90 Oil fired boiler, a motorised valve and honeywell control units. Regards, SMc

Hi, I have an Oil fired boiler pressurized System. All has been working perfectly OK up until yesterday. Now, The Boiler just keeps working all the time and keeps heating the house 24/7. I have tried the following with no effect. - The digital honeywell wall thermostat has no...