Search results

That also. In the exchange the flags were long nosed pliers with flag like side extension used to tension spring sets on relays type 3000 This relay is well over engineered. Every bit on it could be replaced and adjusted. Relay could be made slow to operate or release, could be pulsing, spring...

Just curious. i know what these items are. Was to chew fat over what others did while with that corporation.

Fail to see why folk are hellbent on scrapping an appliance because of its age. Have a client with Mexico who sees 25% ( her words not mine) reduction in her fuel useage after controls upgrading

Posted following in combustion chamber. No BT bods there present or ex Thought will ask here Any here? Know what flags were used for? Or what was called 81s. No1 anyone? Nutcrackers?

Would make sense to locate where the issue is. Boiler may be fine Not looked at any other posting on this thread when I replied

Is Donald going to get a rocket up the Kyber front China with his tariffs the are not holding water anymore Soya for China that was from American farmers is now sourced from Brazil Canada making it hard for US truckers to Alaska

Fit a motorised valve to radiators and instal second zone for HW Fit a system bypass What you are planning gets shoehorned to the additional zone (hw cylinder) Cylinder could be solar coil and indirect if running off plates to heat water directly ( wet side)

The system you have is a gravity hot water system. Water in cylinder is heated by convection currents. Seems some of this circulation is taking place to the rads due to plumbing issues ( there should be none) Be careful wgphere you fit ant valve etc on hot water loop as those 22mm pipes will...

Current flow in resistors will split after the diode as that switch is not made for HW call ( comes into circuit during heating only) To motor to hold it in place To call wire on appliance, the flow will, as you said, be very little

If you do not have voltage then there will be no current.

This forum is a great place to be for advice when the poster does not act the madam. Gas has posted a reply that you can hang your coat on and move on because he has the knowledge and experience. Other posters, too many to name, give their time for free to assist folk with genuine queries.

Not read any previous messages- Pressurise to 0.7 bar ( or what the manual says) while the pressure guage stays at 0 ( heating side drain valve open to ensure pressure stays at 0 Check short while later if pressure still holding at 0.7 Sometimes you can hear air leaking to water side when...

Morris Minor with three seats Usual configuration and third seat in the middle behind the driver and passenger seat. Van was green with a crown on the door and Post Office written on it

ARS licker MTG will be in that boat

Penguins live on this island It is remote and uninhabited by humans Trump has imposed 10% tariffs on the penguins

The floor comprises 22mm chipboard that is grooved for 12mm wet system, 6mm ply screwed every 6”. Was planning to install ldv flooring that comes with underlay ( I think the tiles are 5mm thick). Area is 5m by 3m. Pattern to be herringbone. Should I be thinking of something else for flooring...

He is in the swamp up to his neck standing on heads of MEGA supporters

But is the same going to apply to other festivities

Bit silly to cancel Easter service then it seems if respecting everyone’s religion.

What Hillary did was wrong, does not mean others can and should do the same.