Search results

kev i got it wrong!! you got it right!!! vertical leds!!! it is the same as a brit combi, shall i lower my head in shame????? but it dont have a plate to plate, built in div valve to send round a cylinder

does it have an over ride button on the receiver? think it is the top button, should light up green when override is active, see if it fires then

Why when it comes to boilers do people insist on paying these clowns just to throw parts in. Sounds such a basic fault as well, such a simple lay out on these boilers. I think it would be very different if you picked the car up from the garage and they said it still has the same fault but here...

where is Mr Mouse when you need him, he always finds that extra special way to describe a French boiler!!

Kev thats the original Brit combi that your thinking about, they changed the design on the SE version, sadly plenty got fitted in this area, so have the unfortunate pleasure! :D

think you said enough already, you need to get an RGI which is what you should have done instead of changing the fan, obviously you checked the case seal etc?

if it goes to main flame and then cuts out more or less straight away it could be an Air pressure switch problem or dirty venturi, really not sure as Agile said maybe time to get someone in to look at it, the hot water problem could be related to a board fault or it could just be that the...

did you notice if the spark generator is still running to the point it locks out? probalby the board but needs some one to check that the flame sensing probe and wire is ok

looks like my reply was removed!!!!, you need to look where the leads connect on to the condensate trap, idea is that if the condensate trap gets blocked it stops the flame rectification but the ignition will still work, even if your condensate trap is not blocked it does not mean that the...

stick to your copper and solder if the rest of the house is that way, i just never trust those O rings not to fail one day, if you do use it make sure the copper pipe is clean that you connect to and make sure you put inserts in the plastic pipe, you would be amazed how many times I find plastic...

gland, stuffing gland, all the same thing, look on the link you can see a few of them, you would need to isolate the cold water, remove the micro switch and replace it, depends how confident you feel, i would personally pop a new diaphragm in at the same time, it wont cost much to get someone...

holy jesus, that pic makes me feel like am drunk, see the link www.euroboilerparts.co.uk/productlist.aspx?catid=C2-19

can kinda see what it is, it is simple to replace and not expensive :D www.euroboilerparts.co.uk/productlist.aspx?catid=C2-19

come on Kev it will last longer than an Ideal boiler!

an external one will probably last a lot longer than the boiler you have it is not a favourite on here, has the old one been tested, could just be blocked or need repressurizing :D

looks like the gland is leaking, see that bit that screws in? you can replace that part, your picture is rather small though, hard to really see

1CANHELP I Think your words are a little harsh, ok he was not correct with his facts, but at least he is polite!!

what is wrong with the boiler for them to say it needs to be changed? is there any reason why the tanks in the loft have to go?

having regained my self control after some childishness on my part here goes: Unless you are exempt from having a condensing boiler fitted your installer has fitted something that should not be on your wall, this will explain more...

yeah coz he sounds a tight arse! :D :D :D :D An it probably a dirty system causing his problems!!!