Search results

Just leave the zip open a little as near to the inlet as possible. It will blow dust out but should give you the vacuum facility back.

Should new LED light fittings have built in components to combat glowing when switched off due to induced volts or capacitive coupling.

Does either the programmer or the thermostat need batteries. If not then check the connections in the isolator in case you have a loose wire on the cable supplying the boiler as a first step. But isolate the circuit at the consumer unit before you start.

Sorry I have misunderstood the post and the pic. Just re-rread it and looked at the pic and now realise it is a tarmac strip. I thought it was unfinished concrete.

Why not masonary paint. Once appliedd to render and dried it can be pressure washed ok. It doesn't seem as though it is going to get much traffic there.

Yes mix it up with water and tryit, but might need a few coats to get the colour depth.

Think they are these https://www.ironmongerydirect.co.uk/product/blum-wall-cabinet-mounting-set-brown-837816?vat=1&GSP=true&gad_source=1&gad_campaignid=22180738972&gclid=EAIaIQobChMI9pWS3YDMkAMV5opQBh1FPxIeEAQYCCABEgKlTfD_BwE As Deluks says slacken the screws and lift them up off the brackets.

Buff coloured cement dye or masonary paint

Do a google search for long narrow stepped garden designs. Lots of info

https://www.toolstation.com/flushmount-fitting/p60564?store=EB&utm_source=googleshopping&utm_medium=feed&utm_campaign=googleshoppingfeed&gad_source=1&gad_campaignid=17808634786&gclid=EAIaIQobChMI7Iaf3-jJkAMVuIdQBh0ULQQyEAQYCCABEgLvKvD_BwE or...

So have you only noticed that with the filters out or is it the same when they are in. It could be just that a vortex is being created and circulating in the fan casing.

I always thought that load bearing stud walls had diagonall reinforcement. If it is a load bearing wall I would have expected the ceiling to finish at the wall and not run much into it past the finished surface.

The stainless Yale one would be my choice as you would expect it to last longer if the chromed surface gets damaged.

Op is talking about a bath waste not a shower one. I admit I don't know anything about regs but I stilll think he is measuring wrongly

The pressure switch, usually mounted on the top of the drum with a thinnish pipe going down to the pump or on the rear of the drum assy...

Brushes hard to tell terminal width but ask the seller before buying https://www.ebay.co.uk/itm/156418564453?_ul=GB&mkevt=1&mkcid=1&mkrid=710-53481-19255-0&campid=5338990945&toolid=10001&customid=eb%3Ag%3Avms%3Aeb%3Ap%3A156418564453%3B They don't show brushes as a spare but maybe worth giving...

Not a plumber but I would say no you are not measuring correctly. It should be from bottom of outlet to bottom of bend. I don't think products that didn't meet building regs. would be sold.

Diitto

Post photos ( not too close up ) and give details of your consumer unit in the house and any electrical equipment already installed in the garage as a first step.

An easy get out for them if things go wrong and I don't suppose you would get any warranties.