Search results

You could use uzin 630 primer. Then just screed it all and no plywood.

You can use a pin leveller. I use a screeding trowel. Every bag we mix goes 3m2 ish so I know it’s about right. We use carpet underlay and spray it to the floor or sand to block it. If high we use plywood and silicone

Jigsaw to cut it or we use a exact saw No feather and 2mm screed is to thin. Needs to be 3-6mm thick. We always go approx 4-5mm

50mm nails ? For 6mm plywood ? Should be 19mm. Also make sure they are ring shanks

Fitter 2 is correct. You need to turn heating off and do a moisture test with a hydrometer Needs to be a Reading under 65% RH

Should be no problem but if needed use a feather Finish compound like ardex or similar

Remove all the loose bits , fill in with ardex A46 or similar repair mortar which is a exterior version. Then go over it overlapping onto the asphalt with ardex DPM1c

1965 but most houses before 1980 don’t have a effective Dpm under it so laying glue down LVT will stop the floor breathing which can cause damp. Test it and if it has moisture put a liquid Dpm over it.

1971 your concrete might not have a damp proof membrane ? Can you see any sheet around the perimeter. any reason why you aren’t using a smoothing compound over the concrete.

I use ardex mate . Most are decent though.

Mapei eco prim t

That will sort out the screeding compound sticking to the tiles.

What’s the levels like? Is it glue down or click LVT. You will need to do a moisture test on the screed and the ceramics area won’t have a effective damp proof course for glue down LVT

Did you pre screed thd old adhesive 1st with something like ardex na

It’s a High temp and has fibres so it won’t move at all. The best glue if any sunlight on the floor. F44 is decent but only use it for polysafe these days.

F48 plus is better

Love it. What a bully he was.

Halfway under the doorway. It’s called a door trim. The grippers go around the perimeter for the carpet.

You don’t get much heat with wire UFH through laminate as well. Carpets would be best.

You can put a fan on the glue to help it tack off