Search results

HI there how old would you say the toilet is, and you say you have the cistern off when you took the cistern off did you find there was a plunger type fitting with a rubber on the end of it that dropped out of the toilet syphon its about 4/5 inch long and has a dish shaped rubber on the end. If...

Most of the people who are in spain retire there and their money go,s into the economy they dont work and send their money home to the country they have come from, its totally different.

I use a hand pump spray much easier holds a few liters screwfix sell them less time than a brush.

Do you know chippy or someone who can put in plywood reveals and a sill you could angle them as well if toy wanted let more light in, just a though.

Thats rough as rats whats the plasterboard under the bent sill packing the large gap.

So you can if you strengthen it i,ve seen it done obviously there is more to it but it is possible because i lived in one in 1987 and again in 1996 if the guy is a coded welder he could do it with box section.

Is that curry in the pan yeah as above we have one but it goes over two gas burners pretty good for steaks and burgers.

I would just sink shipping containers in welded together then walls cut out seen it done at white cliffs opal mining in austrialia

Are the taps supplied from a combo? If so when you isolate the mains open the basin and bath taps and also the kitchen sink taps that way all the remaining water in the pipework will empty into the kitchen sink and not on your bathroom floor, don't forget to close them when the pipes empty.

Only thing really is to drain the system and undo the brass fitting in the top of the valve to have a look to see if its damaged inside if it is while its drained just replace all the valves.

Have you tried turning off the one that is hot and the furthest one away from the boiler then open the bleed nipple on the one nearset the boiler see if it gets any heat then repeat it with the other rads.

Kinhell its like the steps on the rocky movie.

Looks like it,s been repaired at some time in between the doors with turus.

At the moment Rodger we have a kingfisher MF 100 with a gravity and return and a pumped return back to the boiler supplying hot water and heating all together.

Thanks Rodger i had a bit of a bashing last time i mentioned a thermal store on here, i know they call them sludge buckets i know i could put a combi in and i know all the issues that everyone has mentioned i just want to change my primatic cylinder and also have a woodburning stove installed...

Why dont you put it between the T&G floor joists first before you put it down on the 3x2 if you cut it so its a tight fit it should stay there till you put the floor down, i,ve just been using recticel in studing if you put it in tight you cant get it back out without damage.

The only reason i ask is its basically the same as the old gledhill cylinder where the water is combined only difference is the hot water is mains pressure through a plate heat exchanger. Thanks for the replys.

I see what you mean depending on how even or uneven your concrete is you could use 50mm and 25mm celotex or recticel it may protrude passed the 3x2 or it may sit flush with the top you,d have to measure see if you have enough room. And its foil both sides.

Yes Rodger the Torrent ECO

I take it thats all i,m going to get then i,m not trying to be clever Dan i,m just saying that is the system i have. I,ve been doing wet plumbing for about 11 years mainly bathrooms and kitchens but not much work on heating systems as i leave that to the guys who do heating systems. But what i...