Search results

Hey foxhole, Thing is, is there is a big void where someone previous has put little white like polystyrene balls in the gap... Seems useless looking at it. Any ideas to build on what you said... Thankyou

Thankyou... I don't get drafts it's just cold... Its so frustrating... Any idea how to keep it warmer behind the units

Hi everyone, I'm trying to insulate the gap between the sunken gas box that depresses into the wall outside and the inside of the property. It looks like whoever did it smashed the bricks and so there is a void.... Can you advise how to do it. Thankyou The first 3 pictures are under the kitchen...

Hi guys, So i have scraped the blue paint off that was under the wallpaper in the bathroom.... However I can't scrap it all off but in time steam in the bathroom starts to peel it more... Is it best to get it all off and then prime and repaint or just prime over it and paint.. Obviously it's a...

Hey guys... So there is no reset procedure in the manual other than fault codes and how to rectify. So i have turned it on and it just shuts down no lights nothing.... I can't find this code or issue.. What can I do now? Regards Ian

That's the one in the picture guys yes. At first it was just the on/off button but occasionally it's also the hot and cold button too.... Setting the temperature does not make a difference to the cut off...... What would you guys suggest next? Thankyou

That's brilliant Thankyou

For some reason my photos will not load.... I tried holding the high/low pressure button down as well as the on/ off button and it beeped and shut down. Turned it off and on again at the isolation switch and reset light flashing as well as high/ low pressure button and continued beeping and...

CBW that seems about right yes. The thing is that the shower then cuts off after 40 - 60 seconds. What would the next step be in your opinion or as part of the service process

Hi Terry I don't have a handbook. I don't know how to reset the shower if I'm honest Ian

The light on the front... The bright blue one which is the one and off button flashed from dime to bright and continues for about 10 seconds when the isolation switch is turned on then it remains blue. Thankyou Ian

What would you suggest next Harry? On the low pressure setting and high pressure setting it cuts out too Thankyou

Could this resolve its self once dried out?

Thankyou for helping so far So i took the head off and it ran a similar time for about 1 minute and then beeped and then water stopped, light on front went out and nothing... Then I just turned the isolating switch off again.... Any other ideas... Thankyou Ian

I'm in the need of some help please?.. I would really appreciate it. So the electirc mira shower I have turns on and then after around a minute it turns off while beeping and the button light flashing. When I try and press the button on it will not start. It will only start again once the...

Hey guys, So I have recently had a garden wall build of red bricks. It had been falling apart due to either excessive cold weather or because the builder is a moron and can't actually build but that's for another day. I'm going to rebuild and I want to clean it of algae and white patches...

So it's not freezing cold... Room temperature would be nice.

It's hard to determined where the drafts are coming from as the damage you see is on the exterior brick and inner leaf.... Its also presumably compromised as these pictures show the recessed exterior meter boxes. You mentioned chipboard? ... The pictures show images of inside the exterior meter...

The 3rd picture shows the screw i turned to alter the compression. it appears that the centre bit which attaches to the other door (floating mullion) there is slight give...maybe from temperature changes maybe? hope you can help thanks guys ian

Hi Guys, Please find pictures attached. (sorry my phone doesn't allow me to upload pictures on this site so I have so send them to my computer) Please see the image with the red circles showing red brick in the top one and in the bottom red circle what appears to be the Instafibre White wool I...