Search results

Hi, Please can you tell me if this drive looks okay? I don't know much about building but guy was a recommendation. It has aco drain on one side (1 brick below dpc) and other side slopes away slightly and ends up 1.5bricks below dpc. Drive very slightly sloping towards house. Will...

That site doesn't answer my specific question though unless i have missed it

I have a very old concrete garage (with asbestos cement board roof) being removed next week, which will leave me with a very solid, large concrete base. I am looking to put a patio in exactly the same area (its away from the house so the dpc is not an issue) How would I lay paving slabs...

after closer inspection its wired as two lots of t+e 2.5 mm into the fcu (this is the only circuit on the mcb) there is one 2.5mm t+e coming down from the room stat but i cant see where it goes and the fuse in the fcu is a 3 amp making any sense? i am going to get an electrician to...

change the wiring?

Sorry people I should have made my question clearer. Would it be easy enough/cost effective FOR A SPARK to put a socket in the UTILITY for a washing machine? So boiler and washing machine on its on part of the board? I just want to be clued up so I dont get ripped off. Apologies for...

There are 10 outlets on the board and 20x2.5mm going into the bottom. Make sense?

I meant breaker on the board. What are they called?

appliance? Its only the boiler on that circuit atm

there are two t+e wires to each mcb

Its on 2 x 2.5mm t+e and the colour of the mcb is a light grey colour if that helps?

To a fused spur for the boiler, on it own outlet on the board? Its for a washing machine, nothing else. Best practice please

the earth wires wouldnt fit into the connector block so i have used a bridging wire from another connector block to facilitate the continuity all seems ok and is sheathed properly

so is it ok?

measured from the floor