Search results

Get a flat blade screw driver on the valves connected to the braided filling loop. Turn the slot so it's in line to turn on and as it is to turn off.

http://gawker.com/german-food-is-driving-refugees-back-to-the-war-zones-t-1762193158?utm_campaign=socialflow_gawker_facebook&utm_source=gawker_facebook&utm_medium=socialflow I wonder is this is true.

Don't worry about it too much... The gas fitter will sort all that out when he fits the new fan and does all the safety checks

no water in the system. Fill it up to just over 1 bar

I agree with using the bolts but that's not how they are fixed in here. Never yet seen on fied in with bolts. It's concrete or silicon.

Take the photos to reece or bunnings to get the right pan connector. Kick the crapper at the top. it breaks the seal and the toilet comes out without damage. fit the toilet back down with silicon. They never anchor toilets down in oz, it's concrete or silicon

Now this is a funny post. Try a couple of hairy caterpillars for eyebrows.. They will stick on with a dab of silicon. Use the eye liner to make your knuckles hairy. I do believe gypo woman love that look.

If the septic tank is smelling then stop using any antibacterial products down the toilet as these kill the bacteria in the tank that eats away at the solids. If the bacteria has been killed off this will cause smells.

How do you check out the acceptable drop across the pipe then if it's not tested between meter and the appliance?

I would think that when the cheque he paid you bounced it was him in breach of contract, I would get advise off a brief as others have said. Best of luck mate.

there's no programmer except the mechanical clock on the boiler. i checked and that's got 240v, I linked out the digi stat.

Hi i hope someone can help figure this out, The boiler works for hot water but when a call for heat for the central heating nothing. Checked the room stat by putting link back in, I checked the clock has 240v. I checked there is 240 between blue and orange wire on x1a and x1b. The pump runs so...

lucky sod. I would love to do some hunting up in montana.

kev are you working as a heating enginner in the states?

sorry i misread it, i Thought the poster ment they had got heating but was not getting hot water.

i would of thought the synchron motor is proberly faulty.

sounds like you need a new 2 port or 3 port valve.

you should not be taking the cover off. get a registered gas man out to clean out the venturis and to check the A.p.s switch. first

the c0 ratio was way out. run the boiler 10 minutes and check reading on fga and the use the adjustment screw on gas valve to bring back to spec in mi

i had the same problem with an halstead ace he making noises like an aeroplane. checked it with a fga and gas valve was out of adjustment.