Search results

Can you take apic of where it is leaking as this would make it easier to advise on what washers you need.Im pretty sure the washer pack comes with the o rings for the hw hex but could be wrong.Paul barker is the man to ask

1 inch of pipe,any chance of taking a pic,what size of rail are you fitting?

Do all the rads have trv's including the towel rail?

did you leave worcester to work for ideal? how come you have an ecotec and an icos?

:mrgreen:

One is for you toove so you know where you set the pressure when cold.so you can check if it's dropping or rising too much.pressure should be 1.5 when cold and when on it will rise to 2 or 2.5 as long as it's not going over 3 and losing pressure there's nothing to worry about.

Circular thing on lhs of pic attached to chasis as stated withe the White wires coming out of it.it had a little button on it just press it,after you remove that black cap hahaha.screw the cap off mate

take the white case off and its on the right hand side attached to the chasis with a little button on it that will have popped out

Seen a few of these,not my cup of tea tbh.what about joining up the vent at the top to the middle and having 1 vent on the last rad?

printed circuit board. any repairs at all recently? start by taking the white case off,dont worry your not breaking any seals. the motorised valve is on your left (white box with a/b on it) turn heating on and stat up and the valve should motor over to port b-heating the wire from...

a leak from the main wouldnt cause a pressure drop. usually a leak can be traced by seeing where it is gathering/staining and trying to trace it back,as it is an Alpha though there are probably more leaks than Jamie Olivers seive

take the white case off.turn your timer on,t`stat up.the motorised valve should motor over to port b which is heating. the m.v plugs into another plug coming from the pcb so you can check to see if there is voltage there. is there any codes? have you had the display pcb changed recently?

I hope this is a wind up.what make and model is your boiler

are they top feed radiators by any chance i.e trv at the top?

check the pump

i fitted my friends mothers and remember a hideous plastic flexi that had to be cut to size.if its a sink and a half try q+b as they sell packs for their sinks and im pretty sure they will fit ikeas.they sell them in bags and are labeled with a letter to match the sink setup.cost about £10 you...

if you supply pipe and iso valve? think i know why he may be free anytime :lol:

there should be a way to get the valve head off to replace it or open it.what make is it or take a pic.this will leave the radiator on full bung though. after youve done this think about entering your man in a strongman contest or tell him to ease back on the weetabix

even custards think boilers come with a lifetime guarantee and you should repair free gratis 3 years down the line

a pike ,will he tarmac my drive afterwards? we could do this all day :D