Search results

I found the correct thread was M14 x 1.5mm pitch

Hi, van passed MOT. Thanks for all assistance. Learned a lot

Hi, I actually removed everything again and ensure everything was in place as it should be and then put bolts\nuts in and finished tightening when wheel was on ground. However still the same. I have no time to do anything else - MOT re0test is tomorrow and if it fails then back to drawing...

Yes, thanks for this. I checked it was as tight as it would go when back on its wheel. I took it a road test and then checked everything again and there doesn't seem to be any play

Yes, I tightened everything up while it was on an axle stand. I think it was when I put van on its wheel again the gap appeared. Everything is seated correctly I think, there is a nut below that which bolts the strut mount to top of strut and it is tight and the strut is as far up into chassis...

Hi, I have a Renault Master van 2013 registration (UK). The MOT failed stating "Macpherson strut pin or bush excessively worn Offside Front (Top strut mount)" I purchased a new top strut mount and also the drop link and swapped them out. All seems to have went okay, however, the reinforced...

I have started doing a lot of my own home mechanics and quite enjoying it so far. I have a basic £10 OBD2 reader used via mobile phone. However, I am planning on purchasing an OBD2 scanner that is bi-directional, a priority function will be that it assists in ABS brake bleeding and preferably...