Search results

I’ve called. No warranty. Hopefully isn’t too much to fix.

Yes! The shower is probably 4 years old I will call now and see if it’s under 5 year warranty as I do not remember. What do I say is the possible fault?

This video is a lie so sorry. I had left e ensure sink tap on while filming https://drive.google.com/file/d/1JL7UOMb0piMNUm3I7XNr02GqnJkiXEvZ/view?usp=drivesdk

I have now just fully opened the flow again.. 00 on boiler with kitchen tap. I will go around and see if I can get the boiler to start by turning in other taps… hw ones

Update… Turned the flow off and went around testing all the hot water taps… No water was coming out of them… Apart from the en-suite shower, that had cold water coming of when the temperature was set to hot - low flow, and faster flow when set to cold. I tested the shower in the main...

I am going to turn the flow off now and go around testing the hot water in each room…

The water is so much water… Hot tap on but running cold water only boiler is 00… 2 seconds and 19

Update.. I can’t the washing machine is on now will once that’s complete!!

I will try this now… When it comes to mixer taps I just set them to as hot as possible yeah?? Will report back now!!

Not at all. That’s when the flow is fully open. But I’ve never let it run for like 10 minutes only just 2-3 minutes but it doesn’t move from 0!!

Video https://drive.google.com/file/d/1HdfR33SOLtUiegOdhX_MVswklJXRppEO/view?usp=drivesdk

4 seconds and 40 This is the hot water in kitchen when it’s actually hot

Kitchen hot water tap one full - boiler valve now off and kitchen hot water has stopped Bath HW not working either with valve closed Same as the bathroom sink - no hot water

Let’s see if this video works… Linked to Google Drive… https://drive.google.com/file/d/1ThoScm3CFjTmQRGzw2WqUlswJ8FsaGba/view?usp=drivesdk I’ve just run the shower (and the water went warm then ran cold again)

Valve opened and this is now the display… hot water tab in kitchen is now cold!

Valve when the water is at 53-56 on display

Can’t add video… this is the hot water display kitchen tab is running. Took photo and now the boiler display is on 53 and water is hot… Will post another photo now two secs…

Of course. Tomorrow I will send a video. What I did was I ran the hot water (mixer tap) in the kitchen - had it running full. Then I opened that blue value fully and the water flow was very high (from boiler I can see the kitchen tap)… that’s when the temperature on the front of the boiler...

I will test properly tomorrow… But have just under the boiler opened up the flow rate … and the boiler just shuts down (not actually) but the hot water display on the front goes to 0 and will not go warm at all…

When you say no restriction on flow… Does this need to be fully open?