Search results

Only issue is this would bring the back pannel out and would be past the 600mm couner top . I am making it easily removable too. Thanks

Hi All. I've installed a new kitchen and I'm just on with putting a end/back pannel across a row of units where the back is exposed. Issue is ,over all the cupboard/draws and backpannel depth meets the 600 mm worktop (not on yet). When I push the back pannel end pannel up against the rear ...

I am doing it in solvent, its only at the trap I was asking about. Which I now have the answer to.

Hi All. I'm moving my sink to a centre island that I'm installing next week. The island is up against the outside wall. I'll be drilling a hole for 40mm pipe under my dpc , is it best to just Mortar the pipe in after I'll make sure I don't damage the membrane etc. (I can't run above due to...

Thanks. So just a radial from the single socket then on 4mm. There's no big loads happening here , all my garage gear is battery or petrol (apart from my strimmer), so just the extra sockets for chargers etc. Thanks

Spoke to him. He's fine using 4mm, but from the sounds of it , he's coming off a single socket that's a radial from the 16a mcb, will he ring it back to the socket ? Is this good practice . There would be a lot of wood boxing to remove to take it back to the board and there's potential for...

Thanks all , I'll have a chat with him later, if you guys think it's alright I'm sure he will. It's going on a 16a mcb that's rcd protected too.

You were correct

So popped my glasses on and looked at the cable, ran some muck round it and numbers appeared, its 4mm grrrr. My swapsy has gone wrong .

There's no markings in the cable

Hi all. My can someone tell from this picture ,appreciate your help

What's the guesses of the guage ? Like i say I'll look in the morning tho

Will do thanks

Thanks. I'll double check it in the morning with my caliper guage , i literally took pictures and put in my van, so didn't really look.

Hi I get cheap as in free due to where I work next door to. Swaps type scenario lol. Sorry the guy said its what gets used in schools etc due to low smoke properties if there's a fire (I think I heard him right )

Hi all. I'm having some sockets added in my garage, my neighbours dad is an electrician, and to keep it cheap, he said I could source the cable and sockets etc, mount and run the cable but not terminate etc etc. Is this 2.5mm cable ok to use, ive just got it free . I was told its low smoke...

Thanks for the info appreciated

Thanks

Hi. It is the frame I'm meaning , 880cm wide frame edge to edge 950cm opening. Thanks