Search results

Morning All My set up is as follows Tv Aerial on the Roof - cable runs down the wall through the bottom of the window sill into an old looking adaptor - then TV cable from there into the TV My 2 year old keeps pulling the cable out :o What can you recommend I use - Id like to...

Wire before - install backboxes then the boarder can cut out the board to fit over the backbox

I found the following videos useful http://www.youtube.com/watch?v=yh0Cp1tFFSY http://www.youtube.com/watch?v=ApDDior4Lw8 http://www.youtube.com/watch?v=CBn11h-s4aU

Hi Zipper. I suspected the prossostat after reading the following http://www.washerhelp.co.uk/diy-repair-help_7.html Thanks for your help I am still undecided on going for a new washer or purchasing a new PCB.. Best decide soon. P.S The washing machine spins OK sowould this...

Im sure the smoke came from the 8 and 9 pin plug due to dampness on the terminals.. There isnt any obvious signs of damage that I can see. Is there a test to check the pressure switch - I have had a look forany blockages etc but all seems OK..

I have reconnected the PCB and the washer is currently on a spin program with no signs of smoke so it would appear to have dried out. I still have the problem with the washer just filling and no program starting.. Is this down to the pressure switch ?

yes water did leak into the bottom of the motor. No error code shows the machine simply just continuesto fill. I recently dried to put it on a spin to get rid of the water in the drum but noticed a bit of smoke coming from the top of the electronic PCB on the right hand side of the washer...

Oh ****** your right .... OK leak sorted but the drum continues to fill with no sign of the program starting - the drum is about half full so far ... im thinking that this is something that might happen once a part has been replaced i.e. has it reset the machine ?

The water leaks from below the element and just above the right hand side bolt of the motor

edit

I will upload a picture tomorrow morning Zipper Cheers

I only changed the NTC I did remove the black hoses that run from the tray but they were replaced and no water leaks from those , I also removed the filter and pump but am sure they are connected back together ok- I only see water leaking between the NTC and the Element.. The NTC pushes in...