Search results

As for the tests, i have just retraced my steps to make sure which pipes are getting hot 1st, the pipe to port ab definatly gets hot before any other pipe including the pipe from the cylinder, so unless it can be explained how this is happening as a return, this must be the flow. I have also...

Hi, i have managed to get the fore off the boiler and as some of you have been wanting to know, the pipes arnt connected as i thought, but they appear to be connected like the baxi bermuda inset 2 manual shows. The only part i cant confirm at the moment is what the 3 pipes are conected to...

Hi all, back again, i called out an engineer to service my boiler, he took one look and said erm i think i will call my boss and get him to ring you, that was the last i heard from that company which i got from yellow pages. After doing this for over 4 months i was ****ed off so ive had a break...

one of the heating pipes is the 22mm thats in the pics where spacer is and above floor is one of the 3 insulated ones 2x28mm & the 22mm to port A. i will be under the floor boards in next couple of days and will be getting boiler serviced next week.

There arent any pipes in the old position other than the 2 28mm which pointed left in the pic and went 1 foot, turned the bends on the top 90 degrees and added 3m of straight pipe to cylinder

Yes the bit of pipe is just a spacer. Moved the cylinder by lableing all pipes, cutting them and reconecting, in the loft i replaced and moved all water tanks and took all water feeds and vents strait up from new position of cylinder. I have not touched any pipework under the floor. The only...

i will get under the floor to see where these 2 pipes go

is it not likely that the return is the bottom 22mm to the boiler, how can we find out if this is the CH return? if i am to swap the 28mm pipes over, this would be so much easier to do between the conduit and the cylinder/pump. Before i do this i think i will get the boiler serviced and try to...

yes i do mean cylinder. the T to CH is the 15mm under the floor which goes down the conduit, this gets hot when Prog HW, 3pv mid and not when HW and 3pv HW. when the pipe to pump gets hot with 3pv set to HW,the pipe out of the bottom of the Cyl gets hot 2nd

I ran the 3 tests today, some more than once because it showed the opposit pipe got hot for definate yesterday, i've marked off where each pipe from the boiler goes. I got the front off the fire and could just see that the right hand top port on the boiler was blanked off, i could see a pipe...

The only difference to the tests i have done is the hottest pipes instead of which gets hot 1st, is this correct?

it cant be difficult to get the front off this fire, does anyone know how? you've just asked me to run upgrademe tests before i reconnect the pump, isn't that what i have just done?

well lets see how this changes things, only managed 2 test today, pump disabled, prog set HW only, 3pv mid gets pipe to pump hot 1st, pump disbled, prog set HW only, 3pv HW gets pipe to bottom of tank hot 1st i want to make sure all tests are done before i reconect pump as its difficult to...

3pv is marked AB, A, B with B going to tank, A going to CH. Test i did was remove red wire from pump, set 3pv to HW and boiler to low with prog to HW on, waited 5 mins and nothing happened, boiler had shut off, i restarted boiler and waited to see what happened, it shut off again after 1...