Search results

What is your standing pressure? ( when taps is not on ) Is it the same as before? Daniel.

I would go for 127mm so you have 17mm to adjust pipe. Daniel

Not a good idea to have two combi. Better to have a system boiler and unvented hot water system. It is all depend on your incoming water main pressure and how much litres per minute it can supply. Best to ask your plumber to advise you. Daniel.

Is the hot and cold fed from tank or off the main? Daniel.

This one will fit inside that soil pipe and then use a standard pan connector for the toilet pan. http://www.wickes.co.uk/Multikwik-Pan-Connector-Extension-for-3-1-2in-Soil-Pipe-MKeb/p/227163 Daniel.

Why? I prefer brass stopcock. Daniel.

Look like a 15mm isovalve been fitted... Where is it leaking from? Daniel.

I don't use black rubber washer at all, only the polywasher, PTFE and plumber putty, that all, been doing that for years. Daniel.

Iron pipe, by the look of. Daniel.

Was there a black bit with a flap inside the nut joint between trap and nozzle? Daniel.

No worries, I have seen those collar ring before in the 70s and 80s. Might ask the op if he can scratch the surface to see if it is plastic or metal. It look like plastic and box in so likely to be internal soil stack. Daniel.

Erm, it is plastic, by the look of it. Op, cut the pipe just outside of the ring socket a few inches from wall, the pan connector will fit in there. The 90mm diameter is inside of the bend and pan connector cannot be fitted inside, you need a clean straight pipe about 40mm long for the...

As above. This is the old gas service pipe and does not belong to you, it is capped so it may be dead or live. Contacting the gas supplier is the best way. Daniel.

May I suggest your mother-in-law get it service by a Rgi ASAP as the corrosion on "a side plate" may get worse. No, it does not have any in-built sensors, it is a very simple boiler. Daniel.

Would this help? https://www.tlc-direct.co.uk/Products/HOH37.html?ad_position=1o3&source=adwords&ad_id=45425533757&placement=&kw=&network=g&matchtype=&ad_type=pla&product_id=HOH37&product_partition_id=74642913187&test=finalurl_v2&gclid=CO_Mx_Sot84CFUSfGwodT-YGBQ Got three channel, independent...

Take it back, you got the wrong pipe Daniel.

May I suggest you turn the gas off without delay and get the rgi to cap the outlet ASAP. Daniel.

If using vaillant boiler, can't the flume management kit be use? Sited the flue as normal and use the flume kit to take the FOC toward to the front of canopy? Just an idea... Daniel.

Yes, the boiler does do the heating radiators and heat the hot water. What exactly is it leaking? A photo will help. Did the engineer inspect the heat exchanger for any water stain? Daniel.

Still have the Record bender, still going strong for 22 years Daniel.