Search results

Thanks i will try to tighten up, but if i need a new transformer any idea where i can buy one from

I have a Texecom Veritas R8 alarm panel buzzing plastic case in the loft and its doing my head in. i can press the case and it stops. Is the only solution to replace it. Thanks

I had my boiler replaced by the guy's that installed my last one and services it. not a full day to swap a Vaillant for a Vaillant and a magna clean, i looked at price to buy boiler and magna clean and thought the price was very reasonable. I have a good family company that i trust.

Sorted and i cant believe what is was !!!! Rang Central heating firm who installed and service my boiler this morning told him what was happening they said change the batteries in the room thermostat its a Honeywell cm907. It didn't show any low battery alarm anyway changed batteries and lo...

Heated up house to 18 degrees so far and now both valves has resistance and pull back if pushed to other side.

Hi Ianmcd Yes i have 2 x 2way valves not 3 way valves, yes worked ok before, i have just put heating on for a bit to warm house and 1 valve the rod has resistance the other is floppy, do you mean the one thats floppy is faulty thanks

Themostat set to 5 degrees but says heating 23 degrees and will not turn off , its a newish stat 2 years old same as boiler which was replaced its a Vaillant Eco tech 613, i have turned off the heating part on the boiler so its cooling down now. I think it is a 3 way valve thats stuck open can...

If thats in the basement it could be the feed from the external DP ( distribution point) i would use a multimeter to check if there is 50v dc across the pairs

Yes there was one in the kitchen it was relocated when the kitchen fitters built a new cupboard. Looks like i need to move it, thanks

I had a new pir fitted when we had the kitchen done a Texecom Premier Elite Compact QD Quad Element PIR but when we open the door the sun glares off the door onto the PIR setting it off. Is there a anti glare per i could fit rather then move the PIR as i dont want to damage our new kitchen...

Hi All I have a Boss therm but, programmer for the water only. its set for the same time every day to heat the water but i have found now that at the weekends we need it setting later in the morning to go off now i don't want to pay to heat it mo-fri as nobody in. i have now followed the kids...

ok i out some miracle seal ct1 in last friday and it not dropped enough to cut the boiler out, i put it to 1.4 bar cold 1.8 bar hot and its been ok until last night as before i went to bed it was 0.8 cold , ok today i still can't seen how its a small leak as the amount its been dropping it...

Hi All so today no heating again this morning , took cover off boiler no indication of water in the boiler , checked all rads and controls when cold no leaks , pressure 0.3 topped it up and it fired and worked ok, its dropping 1 bar over night with no indication of a water leak, only option i...

All plasterboard. i had a Vaillant replaced last April due to loss of water pressure, ex vessel was changed as it was full of water , prv changed and something else was changed cost 3 visits approx £300 in total . Vaillant suggested putting some sheets of paper in the boiler and we proved it...

i assume if its the system i would see evidence of a leak as it dropped from 1.2 to 0.2 that seems a lot of water

no pressure drops between April ( new boiler) and new rads fitted in Dec, definitely no water loss on any pipework no stains in ceiling no evidence of a leak.

I had some new radiators fitted before christmas could that have affected the expansion vessel

no, do i just check that is git pressure or does it need to be set at a certain pressure.

When cold i set it at approx 1.3 bar, no water coming out of prv

getting regular pressure drops in central heating, it dropped today from 1.7 bar to 0.2 i have checked for water leaks but not found any . this happens about once a month. We had a new boiler about 10 months ago and started 3 months ago. With no leaks anybody an idea whats going on Thanks