Search results

Where can I get some of them as my local supplier doesn’t keep them Regards david

Me I would go water butt if no other option available

Not my problem dan I’ll fit the bathrooms kitchens etc if there’s not enough pressure then that’s his problem. I think he using the assumption that the likely hood of all bathrooms being used at once etc

Pressureized system running of something like a 250/300 litre tank. Gas engineer who fitting system recommended it

Never had problems with gas it’s nails gumming up the firing mecs

Tbh I’m in the process of converting a 4 bed house to a 7 bed hmo with on suites so adding another 5 bathrooms to property. Had to upgrades both hot and cold pipes to 22mm and went with jg speedfit running to each bathroom In 22mm then stepped down to 15mm being all pipeeork out where required...

Copper (y)

Run it up the back but have access for service valves and conection Regards david

To me I’d have him back insisting on proper lead and that it’s cut into the mortar and lead sealed up. What you have will fail

Depends if it has a service void Post pic of back of vanity Regards david

Good luck as bit of water in the pipe will mean cut out and re do Regards david

still be a good idea to check filters that old buffer mentioned Regards david

Yes as it will aid the rods to mount the lip as such. Only a few quid to buy on flea bay Regards david

Did you try a wheel attachment on the end of your drain rods Regards david

Pay someone to jet it job done

Use a titan breaker that the hosts sell for about £150. Roughy half hour a post taking it out maybe longer if it’s being a woman lol. For £200 labour I would of expected the old concrete posts remove imho and if I was the customer I would of refused to pay Sorry if that’s come across wrong just...

I run the silicon up the middle of the profile and seal up on the outside once attached. If drilling through tiles 5.5mm drill bit without hammer action will get you through the tile (hopefully depending on tile material) and use a red wall plug. Before attaching silicon middle of profile then...

Plus the silicon on the back of the profile will aid help keep it attached Regards david

Could buy square edge worktops and biscuit join and bolt together just a suggestion Regards david

I’d also change the isolator on the cold feed to the shower to a full bore lever isolator myself and also add one to hot supply to shower Regards david