Search results

Thanks, that's very helpful and incredibly cheap on Ebay. It has a missing part that my old one has (hence hole) so I just hope that isn't the part that failed, otherwise I shall use it.

Thanks but £52 seems incredibly steep :oops: The larger one I got on Ebay was £21.

Can anyone please direct me to the correct element as I just can't seem to find the right one that fits a 1700W machine as they are usually 1600W. I would be very grateful as it seems like rocket science. Thankyou.

Ok, managed to get it out but being a Muppet I have obviously ordered the wrong part. The saga continues!

Ok, I have the replacement and watched a Youtube video on how to get it out. the guy used plyers and it was as simple as pulling carrots. Not so for me. tried pulling the nut on the end of the thread for purchase. It's impossible. Help!

Yes, my brother in law told me it's a hard job but he will do it as he has replaced them before.

OK, so I had my brother in law (more experienced with washing machines) test the heating element with a multimeter and it is dead. The replacement part is only about 20 odd quid so worth the gamble I suppose. The reason I say that is because the control panel is not flagging up any error of the...

That sounds a great idea! Will give it a try thanks. I have a multimeter but I am a novice how to use it to test something like this but happy to learn.

I have one of these LG washing machines that is excellent when working but of late (purchased 2015) the water in the wash fails to heat. The cold inlet is fine as the machine fills up and also runs a complete cycle but the pods don't seem to dissolve either. Contacted my local appliance repair...

He was servicing the boiler.

Ok, thanks. There is a live gas pipe there but it's been there many years. I did ask my gas engineer and he said pretty much the same as you guys. I don't want to chip away at it anymore for obvious reasons.

The builder who did some work on our kitchen was supposed to knock out all the hard concrete and replace with old floor tiles up to the door. After chipping away and leaving a hole he never returned to finish. Can anyone advise what is best to re-fill this hole as I don't think normal mortar...

The front door step area also flaking

There are def no clips on mine in the places they are still holding. There were white traces of white dried adhesive where it had started peeling. I have tried making a wire clip and it's just impossible as nothing to hold onto.

Thanks but I don't think that's possible as it isn't a wire fitting, just adhesive but I'll give it a go!

Sadly it's all peeled away and gone crispy which is odd as it's high temp glue for stoves.

I have just done that very task so hopefully it will work, even as a temporary measure until I get a new seal kit.

Thanks. Can't see any clips but there is traces of white on the rubber that has peeled away which I am assuming is adhesive.

Would stove rope glue be OK as an adhesive?

I have an Electrolux fan oven but the seal is coming away at the top,. There also appears to be a gap which I am not sure if meant to be or snapped. I have some wood stove rope glue that I was hoping would fix it being high temp ? Thanks