Search results

yes have used i on seized gate valves a few of times, ive had a 66% success rate and for the few quid it was its certainly worth a try.

some matki trays are very good some are bloody awfull things that flex badly when on legs, if its been bedded down directly to the floor and it flexes probably tray has some ridges on it and will have to come up. if its on a support stolage you may be able to do something in place but couldt...

turn off water or tie up ball vale and drain system from a drain off some where just enough so tank empties ,wont need much then the cleaner will be in pipework. should really have drained the tank then added but this way will still be better than just in tank .if you just leave it in tank it...

you come to a forum and ask for a opinion but it doesn't match what you want to hear. So you're either wrong or every one else is ,you decide.

probably just a bottle of one shot , smells bad but does the job.

griffin survivor case around a iphone is pretty indestructible , had mine for 18 months phones good as new inside (take it out for special occasions ) regularly dropped ,covered in sand plaster dust ,water thrown at apprentice etc and still working. few testing videos...

the answers been said a few times but untill some one says what you want to hear i dont think this will stop. if you upgrade you gas pipe ,the boiler will work to its full capacity , it will meet current regulations ,be fitted (gas wise any ways ) to manufacturers instructions. If you dont...

I used them when they first started as they gave 5 free leads if you signed up , got one really nice job from it but a couple of other leads I followed were towl waste of time,. First one they were just shopping about and weren't really I intrested in getting anything done ,another saying"...

ACO came with a 5 year warranty, but if it's not been serviced pretty sure there not going to entertain the idea of fixing it as they seem to hate there own boiler. Just replaced a 5 year old one ,on 5 th service 2 holes in heatexchanger ,ariston wouldn't look at it under warranty(5 years 3...

does it have a air vent on both panels ? if so have they both been vented.

i spend a fair bit of time in hospital currently and have nothing but good things to say about the nurses the Dr and consultants on the other hand treat you like a pure nuisance to there day. it did take me a while first off to realise that the HCA wernt nurses as they do so much id assume was...

bit of a how long is a piece of string question ,but a a very rough estimate between £45-£65 per hour 2-3 hours materials not too much unless its on a lead main then leadloc and replace upfrom there . rember it could be a hell of a lot worse and really only way to know is to see it.

yes most if not all the affected blocks(large development 7k + dwellings probally 30+% with powermaxes) round her have been notified by the original builders ,been given free of charge c0 detectors, been told how and probable cost of meeting regs and have been told on each service/landlord cert...

Have 2 sites and mail through 1and1 ,never known it be offline for last 5 years.

Superman did you actually check the link you posted ? even after its corrected and you get on the site did you bother checking the info.

its not part of the inspection you would still get your bit of paper it would just say the aplinace is not safe to use and you would have had a warning label/paper work with it . same as if you took your car for mot and it had 2 bald tires ,you would still get a bit of paper saying failed and a...

if you own a hammer, bolster ,gilbos/ tin snips ,flat lead dresser, angle grinder and a bit of 2x2 about 1.5m long its a piece of **** tony . i worked for a specialist lead company for about 8 years and even though we did some stunning roofs all the vans had at least one of the min guides in...