Search results

Think these may be the same as chivers but can't see his link https://www.lightexpert.co.uk/5x-5ft-led-batten-samsung-led-40w-5600lm-6500k-day/?gad_source=1&gad_campaignid=21877605794&gclid=Cj0KCQiAprLLBhCMARIsAEDhdPcGKin01RFdIDioTS_p2NNBI4NGIhSoOfsqQcA3x1zOVK6LGN4ozscaAjZDEALw_wcB Use google to...

I agree looks like a repair to a crack

Takeb from screwfix community if that helps...

Clamping some mole grips to the brass part, along with your mat will help plus heat rises,but don't know if it will be 100% safe. Was the brass fitting soldered before the plastic was attached

Do you have a drill? Can you drill a hole in the back of the new fitting and then extend the cables inside it.

Water softener.

Outside socket? Outside Fairy lights? Pond pump? Extension lead? Shed?

Same as ebee says, dry contacts are usually switching something supplied by the boiler. If your old thermostat switched a voltage from the stat to the boiler then I suspect you may have bought the wrong sort of stat. Please supply more info ie. make and model of boiler and old stat. and you may...

If the fridge freezer was the only thing you could not isolate it suggests that may be your problem. But is it possible there is an outside socket or lght or something obscure connected to the kitchen circuit

https://www.tlc-direct.co.uk/Products/FD60970.html https://www.tlc-direct.co.uk/Products/FD65118.html Plus some duct tape shpuld be ok I would think.

May be worth trying it again. Especially if you don't keep it full

Sorry it probably was F1, my memory is not what it was and the incident was happening a few months agp. It was caused by a leaking diverter valve FYI.

It's an Ideal logic 35. The boiler does cut out with an L1 or 2 ( I think )code. But when you check the pressure guage to see why it has gone off the pressure is always zero.

Put some de-oxit in the terminals and try again.

Yes it has an internal EV. I think that is why ours works ok at low pressure. The height between the top of the boiler and the upstairs pipework is less than 1 metre.

Is 1 bar not just a general figure suitable for the varying instalations?. Our combi boiler will continue to work until the pressure is almost down to zero. Although it is difficult to tell the exact pressure it falls over at. Or so I noticed after a recent leak. Never noticed any change in...

When was it last defrosted properly.

It looks to me as though it is pivoting on the runner and that the oposite end of the gate ( to where it is catching ) needs to be lowered slightly. I would have thought dropping it just 1 or 2 mm over that length would raise the lead edge that is catching. Diifficult to tell if that is...

Gate should run parallel to the track. Consult the manual for adjustment insructions

Does the ring with the chamferred top unscrew. If you get it off please ensure you rewire it properly, that looks like an accident waiting to happen