Search results

hi i have a table for continuity of main equipotential bonding conductors can send it as an email but the link will not copy for some reason as you can see above it has resistance for 6mm2 and 10mm2 from 5m to 50m think i got it from iet forum

javascript:onOpenAttachment("0",%20false);

hi take the fronts off and see if they have switch lines connected have a look you may have small 3 amp round pin sockets for lamps controlled by the switch

you can get glands for flat t&e they have been around for over 30 years after having said that not had the need for them in a long time

electricians guide to the building regulations page 118 (approved document A) 10.1.1

i think you will find thats the A frame timbers that take the weight of the slate/tiled roof not the jiosts

AMEdinburgh i have sent you message

providing the supply cable is adequate you can use the same isolater to control two appliances as long as each appliance is within 2meters witch it is

have a look at the rating plate on the oven if its not on the back it will be inside the door forget the rating on the link you posted tell us what is on the plate it should be ok to isolate both from the dp switch is the hob electric or gas with electric ignition

in theory yes you would have to test the cable ir test ect is your consumer unit rcd protected ? does the cable to the cooker unit come up from the floor? give us a little more information we will do our best to help

is this a wind up

[/url] and this http://repair4laptop.org/notebook.html

http://repair4laptop.org/contrib/samsung_x10/samsung_x10_display_hinge_replacement.html this site may be of some use

no i was passing on a guy called mike olding on-site calibration services tel07776200146 a few mates have used him they say he is spot on i will be getting him to do my meter in the next couple of weeks you can find him on ebay

hi ban i posted information about on-site calibration i thought you and anyone requiring calibration for your test kit without being without it for a week or so i must have breached some advertising rule must read the forum rules again and give myself a good telling off

hi rf got the same one everybody ques up to slag it off i think its dead on does the job and so simple i can use it

chelsea electrical the most expensive shop in london he has changed his name 4 times that i can remember

http://www.djtelectraining.co.uk/questions.htm this may help

bryan there is no need to change it leave it as it is

give the guy a break nothing he has done is dangerous he is asking advise to further his knowlege help or get of his back for someone who has not completed his eal domestic intsallers LEVEL2 dont be so arrogant