Search results

All slates have mineral inclusions. Some are non rusting . In this case , it does mean possibly a low grade slate. Batten colour does not indicate batten quality . Natural slate on batten one would used 25x50 up to 600 rafter spacing. On the sea front in the south we have hooked and nailed...

It maybe a pitch issue . That can be tiled with valley tiles without a problem .

Insulate the hatch the moist air is getting in there. Picture of roof from outside too

A flat fish so shallow ponding will be ok

There's a lead tray low in the wall which would protect the lower roof which I think is your neighbours as it's low down . This leaves the higher roof unprotected from water within the brickwork above that tray . That's what I see .

Let's see your roof too. Ideally seeing height difference between yours and his a bit better

Put firrings on top then new deck and then a proper roof covering .

There's lots of knock ons.with this not just money

Check with nfrc

Clay tile mansard with a small flat roof area with a Velux window on a velux kerb I'd say Possibly the building was extended but ridge height kept the same for planners

It maybe just a dimple change of roof pitch . You need a photo end on show pitch of both sections

Insulation is rubbish

Builder . The roofer should have highlighted the lack of fall though . I'm surprised the roofer decked it anyway

Better grade slate for one , and the other is you used slate hooks . Other than that well done

Is the stack blocked off inside the house ?

Even the worst natural slate can be laid to look ok. Here , there is lack of care and skill . There are rusting pirites which indicates a low grade slate . It's just a mess

No not good . They really need to extract to the outside . The vent tiles are doing nothing if the underlay isn't cut. You could get a guy to lift the vent , modify the underlay fit the required adapter and then connect up . Depending on tile type it will either be an easy job or a fiddly one ...

Might be water finding it's way around the dry fix screws . Rubber washer may not have been fitted

Klober do universal vents

Marley segmental ridge