Search results

It won't be in the cavity, drill away you will be fine.

It's reedable so who cares? If it's important to you you may need to Get a life. :)

It will work, maybe to well so may need to be balanced down a little. If you have the thermostat in one room normally it would be better to take the trv head of this rooms rad.

I would think avoiding damaged lungs a good "excuse" in my book. Good on him if he's spotted asbestos and wants it dealing with correctly. Too many dangerous contractors would have just put a hammer through it and risk there customers health for a few notes.

WB are good boilers. Most engineers on the internet who complain about them is because they can be a pain to work on due to poor position of some parts. From a customers/ home owners point of view who cares about that. There biggest plus is they have the best customer service of all...

Do it as newboy has suggested. Good advice

Storage system?

If you do it that way you will need a sweep bend at the bottom, access above that. Support the weight of the pipe work off the floor. Is the existing not vented? Post a photo of the whole outside pipe work.

Check appliance manufacturers instructions.

As far as I know only WB state you can get away with the rubber only and seal from inside. A 5kg bag of sand and cement is £3 a cup of water and 5mins work, whats the problem unless your a lazy bar stool.

WB may allow the rubber to be the seal but they also ask for the gap to be filled from the inside which suggest they only expect this to be done on flats above 3 story (for access reasons) imo.

Def needs a gas upgrade, boiler position needs to consider condense and boundary issues, propa flush out etc..... Get a few quotes and compare them.

Sometimes they are limited by agreed service contract but they will def have a heat only solution for houses not suitable for a combi, they just won't push it due to margins etc....

I would just get him back to fix the radiator valve and get somebody else to fix the filling loop problem. If it was in poor condition he should have discussed this with you when the install was done. I would have changed it for nothing even if I had not included it in the quote as it's...

Apart from doc m, no real distances, you may find recommended distances from manufacturers, authorities etc.... But nobody would care or check these apart from maybe an NHS job

Def a wiring fault , get them back, keep boiler stat turned down.

A heat only would be a cheaper install if it can go in the same place as the solo. Speak to the council.

Has the boiler been moved? as it looks like it has some patching material on it already. The outside needs patching ASAP as any decent engineer will turn it off in this situation. Outside use sand and cement, inside I'd remove the old stuff, fill with sand and cement a few mm below finished...

Plumbs do a center brand wireless programmable stat for 51 quid, it's made by Honeywell, an up branded version of there 120quid stat

Phone the manufacturer back and ask them to email you a copy of the instructions, print them off.