Search results

Honeywell

It's likely the red and yellow pair do the switching whilst the blue is a neutral , if so you need to be carefull where you connect the blue

No idea , will have a look next time i see him, not seen any gizmos its still wired in to an old screw terminal junction box, reason bit of both i think bit of nostalgia and of the mindset of if its not broke keep it, his wife has a mobile though. He still has old test meters with PO...

mk k2200 may do the job There is a bloke on ebay that sells custom made adaptors for about 18 quid

We recently had extra boxes stuck on all the poles down my road ,i have one right outside my house , the bloke opposite still has an old dial phone running from a a copper cable, as an elderly ex post office engineer he refuses to change, i am connected to this same pole but with a fibre cable.

The Metrel i sold you last year

Do you recall the single 50va units that also weighed a ton and had little 3.15 A fuses built in the end that often blew, i see you had open front dichrolcs thats pretty old school. 12v seemed to really change shopfittiing till then round here was all Concord track and crown silver es lamps...

She is possibly safer without it, went to a few premises where similar had caused fires, I believe the invidual outputs were not protected just all commoned up to the one transformer output and back in the days 50w lamps were common,. and when the 12 volt lampholder wires burnt up and...

We used to use them for data outlets but noone really stocks them or fcu units nowadays, so its actually more convenient to get sockets and swop out the relevant logic bit to suit our needs

Easy, the plastic lug with the metal discs hold them in, release the top two and the socket falls out, theres three ways either 1, totaly remove the top two discs which is hard as the teeth bite in, 2, bend the metal lips up one side then bend down again after or 3, my favourite lean the...

How big were the stocks to thread 2 inch back in the day

Most rope edged accessories are oversized

Plasterbox knockouts are usually angled and recessed , i assumed that was so the cable would always exit slightly lower or higher forcing horixontal cabling to be behind the box and in zone, subject to room behind the box

Back in 2011 there was a few police driving round london with BO11*** numbers, some were quite amusing

Whats that bottom right corner, is it a cut off pullcord you might have pulled accidentally and turned it off

I remember that, think YT2 was made by EGA well before marshall tufflex MT2 or even sticky back

To be fair your choke/ ballast looks good, are you sure your using the correct starter, as a failed choke is unlikely to cause the lamp to flicker

Hi Harry missed this, I have 35w as well as above message me if your interested, let us know dimensions, will do you a vert good deal

Hi Harry, I do a lot of shopfitting and MH gradually disappearing, I have some new 70w electronic ballasts, often there's room to remove the ballast and ignitor and slip them inside, if your stuck and interested message me. Orbis 70 ballasts or similar as are the ignitors are still about but...

Yes that's suitable , also Tridonic EC 18 is a good brand and some still about new,, I assume its a 2ft fitting