Search results

it's not a must

try reading the water regs then. which proves you ain't got. :wink:

what is it your doing ?

i know your not a plumber. but thats something else you have learnt. :wink:

has been known. but not allowed under water regs.

plumber for the council. say no more. how is lowering the temp going to save water, electric or gas maybe.

maybe you have shut someone in their and it's getting to hot for them. :roll:

whats the temp got to do with saving water :roll: don't be so tight.

check the flow switches on the pipe outlets from the pump they can stick

sani will be ok

you flush whole system from one point and shut all rads then open one rad flush for 5mins then open another rad and shut the first one. then each rad getts full flow through it. i always use fx2 in powerflushing. but you must neutralise the system after as it is acid based. and be careful...

or i use the pump adaptor.

shut the other end and let that pipe flow if thats the cold pipe and airlock should shift.

if shutting all other rads didn't move it. try shutting both rad valves and disconnecting from rad then open the cold one over a bowl. letting the water flow can sometimes shift the airlock in the pipe, then refit

go on then we've not had a pic yet :lol:

fit new motor. only cheap.

wheres the diagram ?

plastic cap or a durgo valve ?

your motorised valve next to your pump

usally cut them off an have just the white pan connector out the floor.