Search results

You don't have to take the soil pipe above the roof as long as you lol air valve on around 1.5 metres above highest water inlet

When you have it located in the trench you then bring a soil stack up from the the ground , Yes off through the wall

Anyway if it was just a path my tuppenc worth would be to dig a trench lay a new soil pipe under ground connecting to the present one and put it where you want it . Yes a pain having to dig a 45cm trench but a macerator will cost you £500 , they make a awful noise, get blocked and then you need...

Thanks for the pic makes more sense ! Personally sticking a soil pipe along the outside wil not do anything positive for the look of your house ! It looks like there’s a path that goes down the side ? Concrete ?

Thanks cdbe prob use tape as I normally do it’s just that it’s got timber behind the plaster board where the gap Is and I can see it moving … last time I did a 45 degree corner I used a 3mm stop bead :)

As a pro I try not to Use macerates they are a pain in the bum when they get blocked! Could you possibly fit a corner toilet in there close to the soil Stack? Pics would really help ! Best wishes Jake

Only way to know is to remove it

It doesn’t matter what board you use the idea of tape is to stop the plaster from cracking when there’s movement on the boards bestwishes Jake

Have you a photo ?

Hi Still got a Lot to learn about plastering as it isn’t my trade however I do do it in my own house to get more practice I Just Wondered if it’s possible to use metal CornerBead on a internal corner? Where I was thinking was wall meets ceiling? I usually use tape but got a few gaps to fill...

I was waking around my house today doing some Measuring and realised the chimney breast in the living room Has one directly above it however there’s not one in the kitchen but there is directly above it ? All the houses down the street are the same, there’s no fallow brackets or steels Etc I...

Hi, I’ve got some external Block Work That I’m rather going to render it tile, im Planning on putting some tile Backer board which is suitable externally onto the block work first. I wondered what would be the best way to fasten it to the block? Thanks Jake

Thanks again woods … after removing the brick work on the pic timber is definitely the way to go thanks Jake

Afternoon , Just thought I’d ask you guys for suggestions on how I should rebuild this little section of the wall? It’s approximately 1 brick length wide and single width There’s a piece of 4x2 which acts as a lintel for a cupboard door and on top of the brick work the is a joist which at...

Thanks guys

Hi , I’m just in the process of removing a wall, the corner of the wall ( which is in the photo ) is going to be replaced with a wooden post 6x6 or 8x8. Currently the joists meet at a tee section( sorry I’m a plumber lol ) and below that it’s just resting in the wall. Im trying to figure the...

Thanks

Morning, Not sure this is the right place to post this question ! I'm just in the process of doing my aco drains, Is there a way to overlap ( side by side ) a aco drain? I've got a brick pillar in the way but it isn't enough corner to put a corner to get around it , I can't move the acos...

Afternoon all, I’m removing the wall between the living room and stairs and just wondered if I could rack your brains too get some good ideas The wall is brick however at the top is lats and plaster( top part is staying Also on the wall there is a hood running across at the beginning of the...

Hi Jeds, The 3x2 size of a porch would need building regs and planning as it’s too big to be a permitted development. It’s just really confusing re the window as it doesn’t state anything thanks Thanks Jake