Search results

We’ve bought a new build And due to the amount of remedial work and quality of paint work, considering re doing the house. How much would you say it would cost DIY vs Labour Most areas are in good condition, just needs the odd sanding, undercoat and paint. Been looking at scrubbable matts...

I’ve used Geocell and Everbuild Caulk Once

Couple of mill, one gap at the top between the windowsill wall and foot is a bit bigger

The caulking around the door is

I believe so

Hi, We purchased a new build around 12 months ago. House is about 18 months old now How long would expect to keep seeing shrinkage? I’ve re caulked out front door 3 times now and it keeps cracking. I’ve used shrink resistant caulks etc

Feels a little cold

If you look at the shadow line in the first image, that’s all raised and swollen

Just noticed these two skirting boards are swollen Any ideas of the potential cause?

Is there a caulk which stays white Not silicone sealant I want to put some in the gap where the bannister meets the wall see pic

Need a small quantity of mortar for some repair work on the house. Anyone had any experience with it? Looking for one to match below as close as

Hi, All of our skirtings and windowsill are painted with Dulux High Gloss All of the areas covered by photos, ornaments etc have gone yellow. 1. Will the colour return to normal? 2. Are there any products that don’t turn yellow?

Not sure that will work I’ll try wood filler again today, as it worked on a few other holes yday, just this one had too many to screw back into. if not I’ll get someone to replace that section

Ground under the joist, it’s suspended of the floor a couple of feet

Partition like so

Yes Hollow The fittings are placed between two boards with a gap in between for the fastener linked above. it’s a small opening to get anything in like a dowel or toothpicks as I can’t trim them with the space available

There one size fits all, they aren’t standard screws either they have a tapered edge

Similar system to this yes

Drill on screw drive mode And been hand screwing the loose one after trying filler today.

The fastener screws are a one size fits all. There just the right size to fit on the fastener