Search results

Could do, just got a selection of JBs at my old mans house. Would prefer to recycle than throw away. (maybe i'm to tight) LOL

Hi. This is an old cooker connection with the connection grub screws missing. I need to get some grub screws to fit, i'm sure these are the same size and thread size as a 32amp junction box? Can anyone confirm? Pic attached Thanks

Hi I have today rebalanced my heating system. But now I find that some of my rads are making a hissing noise by the lockshield. Any ideas what causes this and how can I stop it. The rebalancing has worked and now my rad are now really hot. Does balancing a system actually give better...

Hi does the rcotec 831 combi have a manual pump speed adjustment or does it modulate? Thanks

I have now confirmed via the test tube test that I have hydrogen forming in my system. I always get air forming in my highest rad (towel rail). My system is a 2 year old ecotec 831 together with 8 rad also 2 years old. The pipe work with the exception of the rad tails is old. I...

Thank you for your reply. I know the way that I want to do it I'm just checking that I can do it that way or are there easier ways. I suppose it like asking for guidance so that other ways if possible can be explored and learned. I will wire from a plug to a 6a 1 way switch then from...

Hi All I have a small light batten in my shed which is connected via flex to a plug socket, when I want to use the light I have to go through the shed in the dark to turn on the switch on the plug socket. Is there a possibility of me adding a switch by the door to this circuit so that I...

Many Thanks, I fitted the original socket, I rember doing the drill hole in the bottom. Thanks

Just along an outer brick wall with saddles.

Just along an outer brick wall with saddles.

What if I use SWA box to box?

Hi I have a MK masterseal single socket in my garden, this is fed directly from the CU on its own circuit with 2.5mm cable and a 16a mcb I now need to add another socket in the garden (other side about 3m) can I connect up to my existing socket using some 2.5mm cable in plastic conduit...

How often should the inhibitor be changed in a combi system. I'm currently using Fernox F1 which has been in for one year. When it does get to the time to change the inhibitor do I drain down 100% then refill with fresh water adding fresh inhibitor. or do I just add the inhibitor into the...

you can do this - plug unit into the downstairs ring then pop off the upstairs ring to see if you get the drop. then move the unit to an already tested ring and plug in there, then drop the downstairs ring.

Hi The pressure remains at 1.4b constantly.

Hi I have a Vaillant EcoTec 831 Combi, with 8 rads. I seem to always get air in the towel rail which is the highest rad in the system. If I run the heating for a few hours the towel rail will go warm then I have to bleed air out of it to get it red hot again. The sealed system has a...

Hi My small block paving pation 4mx2m runs toward the house and then to the left where the drian is for the gutter. The water does not collect and does run into the drain but goes towards to house doing so. There is no water puddling near the house and the block paving is well below...

I'm doing a small area in my garden for a small patio (2mx4m). I will be digging down to remove some earth and making a base of type 1. In the area I have a small trench already where the soil pipe was repaired this is now back filled with pea shingle, is it ok to just put the type 1 on top...

I have used it for both, for mist coat and for finish coat. All the ceilings in my house are glidden contract matt.

I would rub down to give a key, then prime with Zinszer then so coats of flexi gloss.