Search results

For some great tips have a look at http://www.pavingexpert.com/repair.htm

The colour system is the same as the UK ie PAL. You may find the sound sub carrier is slightyly different so no or muffled sound if you use the aerial. Scart lead would be fine.

For a good diary of a shed build , Have a look at http://www.gisburne.com/shed/

Was the TV working when put in the garage? If so, its probably just damp if is as been left in a garage. Have you ever removed an EHT cap from a tube before? If so, remove it and dry everthing out with a hair dryer. If not the proceed with caution. I saw my Mother once pick up a tube that...

Sand, Gravel and Cement..

Have you a fully pumped system with a three port valve? If so , it sounds that there is not enough flow through the boiler. Try turning you pump speed up to increase the flow.

They may be clay pavers..... You need to tell us what sort they are..

You can only turn the pavers upside down if they are clays, not concretes. Try some washing powder and water with a scrubing brush. Works a treat.

She's with me helping me open my fridge motor.... :lol:

NO, due to the fact the socket you are pluging into will still be on the rcd protected side of the CU. You need to get your fridge looked at if this is the only thing that trips the CU RCD.

Just closing the radiator valves does not prove if it is a two or one pipe system. In a one pipe system, there will be a bypass pipe underneath the radiator which allows flow if the radiator is shut.

Thats a clever way of dropping in an advert.... :D

Depends if it is a flow and return two pipe system or an old single pipe system?

The tool does not bare the wire. . What happens is the krone block you push the wire into, cuts the insulation on the wire so it makes a connection. The tool is just for pushing in the wire. On a more expensive tool, the tool pushes and cuts off the excess wire all in one go.

Was the pressure OK before you fitted the mixer? Have you used flexable hose to join the old pipe to the new mixer? The hoses (if fitted) could be too small a bore to let the hot water flow.

It should be a 6.8K wirewound resistor

Yes, but you will have to get building control to come and inspect it.

It all depends on if they are clay or concrete pavers you are asking about?. You get less pavers per pallet wthe cheap 50mm concretes than other brands.

I find most CHEAP jobs are due to people doing a bit on the side and nicking alot of the stuff from their employer during the week. How can a one man band compete with that..... :roll:

3 ton for a ramp is alot of weight. I would ask the power rating of the original motor to see if it is worth while to convert to single phase. Most single phase motors max out at 3hp.