Search results

Hi all, thanks for the help. I managed to sort this by linking the wiring in the thermostats, used a block connector and then i had to add the separate receiver too. This too needed a link wired adding across, so bridging the permanent live & pin 3 for heating. All good now. Just for info I do...

I will need to add a photo of the wiring, and connector. If you could advise that would be great Also another bit that confused me... so i have the heating wiring only has two wires in the original danfoss receiver, when placing these wires into the Hive system I have added them into pin 4,(2nd...

If that is the case do i need to find the other end from each original thermostat, disconnect it and then link in a signal at the water tank upstairs signal box ?

Hi I removed the wires from the each thermostat and just secured them in block connectors. So they not connected to anything, the new thermostats are battery operated and have no wiring required. I didn't locate the other ends though. Interesting to note the original wiring for the heating only...

Hi all I am new to this and please could someone assist, I am trying to install the HIVE dual zone system and have an issue with the heating. Current set up is a Danfoss central heating system, with 3 zones. The boiler is a Potterton promax 15 located in the kitchen, with the main controller...