Search results

imho you'd be better off fitting bath first, sealing it to the wall with silicone, then tile and silicone around again after - double seal achieved.

Took it to be a combination cylinder....

new washer in the ball valve...

Jaga do a two piece covering rosette for 15mm pipes at 50mm centres. If you download the LST cataloque from the link below and check out page 48. Don't know how difficult they are to purchase on their own though. http://www.jaga.co.uk/products/catalogue/lst

Not enough initial flow due to insufficient head of water above height of the shower head probably....

Alternatively, the cold feed could be the teed in last on the return to the boiler...

Most bar showers have 150mm pipe centers and hw on lhs, so would be a straight swap. Worth checking that the filters on the inlets are clear and that you've got flow on both hot and cold ok first though.

The stowaway in the back of the truck at the pumps must have crapped himself!

John, we accept your point and diyers are free to do what they like including taking your advice, but you must realize by now that the vast majority of pros on here think that what you recommend is a bodge, and from their experience as pros, recommend the likes of jet blue. I'm sure diyers on...

Dan, you have far too much patience! Let the bodger bodge....

It certainly needs protection and best allowing for some movement. I would wrap it with pvc tape - spirally wound with 50% overlap is the way... then put pipe insulation around it, then wrap that aswell with pvc tape - 2" tape would be best for this bit. Then concrete it in without stressing or...