Search results

Cut a small section of down pipe and put that in the 112 offset first, then put the pipe in.Drill a small hole and and put a screw in,this will hold it al together.

Thanks pinky,that should do the job.

Going to put a new sink in but its slightly different in size.I would like to cut worktop from the top with a jig saw,i know this is the wrong way round to cut it .Sure i read you can do it somehow the other way up.?

Is it stop tap off,combi off,drain taps then fix new ones.

Is the kitchen now what was once the coal hole?

Have i got to turn off the combi when fiting a new mono tap ?

Its the old story,do i do it or let the next buyer have the job.Cant you ask the blokes doing the leadwork what the condition of the ridge tiles are? Why not sell the house in the height of summer!

I have to quote to re-roof 10 garages that have old asbestos sheets on them.I would like to put metal box profile sheets 5.5mtr in length on.The garages are of a pre formed type concrete panel. I'm thinking of fixing some wood beams,say both ends and middle to take the fixing screws.Anybody...

I've done a few of these using leadmate,really go to town with the wire brush.Do both facing sides of the lead with the wire brush,then i put two lines of sealant and dress the lead back down.Clean up the excess lead that might sqeeze out with a rag.

How much does a hole cost these days.

Yes i took it off and pushed the pin up and down a few times to make sure its not sticking,left it off and its still the same.Could there be a massive air lock? Only when i bleed it no air comes out,and the bottom of this rad is luke warm.

How do those tops come off?

If the thermostat was fitted to the wrong side of the rad would this effect it getting hot.I've done the bleed bit with boiler off and rads warm.Its a double about 1200w.It does get warm but not what i would expect with the thermo on 6. Can i test it by hand,like the hottest pipe in..

Looking to buy a concrete breaker,without drill.Checked out a Bosch today,bloke said it was a light weight but done the biss.Cost about £330 mind,not looking for a large one especially when holding it up getting render off!

How about putting some plastic tongue and grove on it.Some of the wide stuff,soon have it covered.

From what i saw on rougue traders on bbc tv,they are just about 100% the property owners! That chap went and took half the block paving up,because he only received half the dosh.I think the police arrested him at dawn.They said in France it is criminal,but here its civil.Its the old Pay back £2...

I'm repairing these all the time,nothing sticks good to the outside of these but it does on the clean inside .I use flashing tape,i cut a managable strip then play a gas torch over the tar side.I then pick it up on a corner (using gloves of course, its going to be flipping hot!)then wack it on...

The problem,a row of garage lockups.There are about 8 garages in a line,the rear wall is quite high about 12'.This wall has moved away from all the seperating walls on each garage,the crack runs from top to bottom on each wall. Cant put a retaining wall on other side because there is a small...

Try a small area first with the horse hair mix,dont press it to hard at the battens,wet the back of the slate with water to help it stick.Might be able to use something other than horse hair.