Search results

You can use either, the white ones will be the same as the failed ones you have.The black ones are softer C00251802 and will give you a better chance of a lengthy repair.

They are the extra hard laminated brushes that overheat and stick in the holders. Try a normal set C00251802.

Most likely the inlet valve on the machine is letting a small amount of water in. Shut the water supply off and you should find it stops seeping in, then change the inlet valve on the machine. The brown part of the water softener is the crystals and that is the colour of them leave alone.

That is a mains suppressor, mains filter, mains smoother it protects the electronics. You have a brush motor not an induction motor so no capacitor. Tumble dryers, dishwashers have capacitor motors. Motor capacitors do fail but I can assure you that is not the case with your machine.

It's a brush motor, it's a suppressor, it's not a start capacitor. Please don't confuse the OP.

The capacitor is a mains suppressor, nothing to do with the motor.

I think you press the quick wash button, once for quick twice for extra quick.

The shock absorbers should be difficult to compress by hand.

When the machine is empty of water put it on the drain cycle take the filter out and see if the pump impellor is turning . Selecting spin only on a Bosch does give a one minute approx. pause before the drum starts turning.The PCB is behind the fascia.

Have a close look at the lower spray arms, they sometimes spilt on the side seams and put a sideways jet of water out, overwhelming the lower seal.

I would check the clock isn't on auto for starters.

Yes. Power off, pull the cooker out, remove back panel of cooker, locate the two screw heads and undo.

Please OP, take the back off, find the two philips headed screws and undo them. regardless of whether the new one is threaded the old one is.

The original element is screwed in from the back.

You need to watch it and see where it's leaking.

Having issues with this boiler, every 24hrs or so I find the central blue light flashing. If I do a reset it will try to light and eventually will. While its trying to light the flame light under on off comes on and what sounds like the fan comes on. After 5 or so attempts if it doesn't light...

F21 on older Bosch machines usually means worn motor brushes.

have a close look at the front contacts of the selector switch, you may find they are damaged.

Try AEG, Zanussi, Electrolux part no. 4006020327. it goes by the make of motor used.

Try bosch 427903.