Search results

wos a threded barbed connector

Now you talking about Underfloor heating. You have no money

Andy, Was thinking about undersink units for bathroom and kitchen (Redring Powaflow or something like that - I know Heatrae Sadia do something along the same lines). I've got a HW cylinder with immersion heaters that runs on E7, but it is still expensive to run and won't support wet CH...

I want a jag but my garage is not big enough.I am only prepared to pay for a push bike. But can i get a jag. How can i do this anybody got any good ideas

Off course did not think off the condense pipe this has to be run in 32 mm if its over 1.2 meters

You could always try Heatre sadia electric instant heaters above all your sinks and bath. Or a seperate hot water cylinder with emersion heaters, but you have not got room for that, and your bills will be higher. You could always get a gas boiler fed from propagne gas. but i suppose your budget...

The discharge pipe has to be run in copper. It also has to be run in a downward route to its discharge point .

You could get an electric boiler if you dont want gas.

Sounds like you need a new gas pipe. The route you take is up to you and the plumber. As for the lead water pipe i have not heard of lead fillters but there might be some out there that claim to work

Water will not come through with a leaded slate they lap under the upper tiles and overlap the bottom tiles, this actes like a slate so it should not leak, as far as insects getting in theres probably thousand of tiny gaps in the roof for them to come in any way. If you look in the loft in...

How do you connect the gas pressure manometer to a gas test point? I assume some sort of threaded/barbed convertor is required to connect to the rubber hose? Your avin a laffe

Why not use a pressure gauge.

See if you will be accepted for the training first

How much did he charge 8) 8)

Only addvice you should get is to follow the manufactures instructions, and use the proper fittings

If you ask them what is the average cost is, you might get a rough idea. It depends on how much you want this sorted. Old victorian properties just had one lead pipe feeding a kitchen sink, toilet and bathroom. Since then people have added wasing machines dishwashers combi boilers showers and...

What you need to do is pay for a new and seperate supply to your property. The water board will do this as long as your prepared to pay.

I cant see how his pipes are on your land. Thames water might be responsible they might be shared .The pipes on your property are yours.

This also happens when the boiler thermostat is faulty. The water keeps on heating up and travels around the pipework, it normally heats up the F+E tank . This would explain the steam in the loft

The gully should be moved to outside the extension. This should be in the drawings