Search results

I am fitting a new kitchen and new extractor hood but the new oven will be moved about 6"so i will have to fit the new hood about 6" away from old one . will i have to drill a new hole through the wall or is there a way around it? longer trunking etc ?

Washer now scrap screws broken of in body (rust)

thanks but have checked both all clear ?

I have a McCuclloch power mac 1300 washer . when i turn it on pull the trigger the water comes out the lance and it will fan but there is no pressure. The pressure gauge is showing zero and doe not change if i turn the pressure adjuster ? could it be the brushs? on the moter thanks for any ideas ?

Hi can anyone tell me what the operating pressure should be on a McCULLOCH power mac 1300 power washer, the dial goes up to 160 bar and just over 2000 psi ? thanks for any help .

All done now i sealed every thing that came together with plumbers mate =no leaks .thanks for help

someone said seal with plumbers mate ? what do you think?

i was going to seal both as i dont thing its the leaking past the washer but i will check by filling with water thanks

thanks for reply will remove coupling nut and washer and try sealing on doughnut tomorrow . John

Hi Iam trying to fit a new siphon but after fitting every thing back together i have a leak under the cistern it looks like it is coming from where the siphon is fitted thro the cistern, the rubber ring in on the inside as required and is tight . i had this problem with the old siphon and had to...

thanks tony inside the pump sounds like someone frying chips have blead it and i think it is ok now but will try again to morrow . thank you all for your help . :lol: jack

thanks cris not much air in there. water is now getting hot boiler starts at 46c runs for about 45secs cuts out at 63c i can hear water running round then i starts again then cuts out at 63c is this normal ? thankyou. jack

Hi today i drained my radiators to fit a new valve in heated towel rail in up stairs bathroom have turned water back on blead rads heating is working ok but hot water tank does not heat up no error nos. coming up on boiler but lot of water gurgling noises ? last time i tried it shut down :cry...

sorry i cant delete this bit ? cant find delete ?

hi i have brought a honeywell T6360B to replace my satchwell tlx2259 satchell = 6 (2.5) a 220-240 it has 3 wires red. bl;ue. yellow. no earth ?. The new honeywell has 5 connections earth. 2.3. 4. 1. i have been on the phone to honeywell technical and the lady there says the live goes to 1...

I have opened the gap to0.50mm i dont think it was 1mm before as this would mean undoing the nut and i only undone the screw that goes into an elongated slot . it is not working properly so i think i may need a new one ?

thanks for your reply i was going to buy a new one but can i get the same one so i can do a swop with the wiring ?

hi does any one know what the conntact breaker gap should be set to on a wall room thermostat mine is on the lounge wall and when i was wallpapering i unscrewed the wrong screw and the gap moved . the thermostat is a scatchwell . thankyou for any help .