Search results

The price is for the work that a company intends to carry out at my mums house and is based on two hours total time using the materials listed. the price assumes a straight forward job of stopping a small leak on my mothers installation. I am only asking is the price for the work listed...

Please would someone tell me what would be a reasonable price for this work? 1.drain down hot water cylinder 2.drain down heating system 3. replace nut and washer between coil and cylinder 4. replace 28mm to 3/4 female prestex 5. refill system and test out My elderly mum has been...

Thank you for the info will have a look again later but a quick calc tells me i need 5420 btu. :D

Thank you for your reply, what are the calculations is this something i can work out? Or is there a general rule of thumb? regards dcw

Hi all did a search but could not find the info. my question is how many radiators would be recommended for a room 5m by 3.5m? The room having one window and a pair of french doors. The single radiator is located on the opposite wall to the window/door and is 1m long cheers :)

i bet you are well pleased to have found it :D

Thanks guys I am an electrician but these guys have been paid to install this system so i am not getting involved yet. The company is corgi registered but not sure about the sparks, i was away when the install was done. i have just checked the stat and there is a live coming back from the...

hello we have just had the above gas boiler installed and initially the room thermostat worked in reverse ie turning it down bought the system on. now i am a bit confused as to how this system should work. The boiler has a control knob to set the radiator temperature which i have set to 65c...

Last time this happened to me it was a pint of milk under the passenger seat which had been forgotten about. It had split and my god the stink was awful in the end i had to cut the carpet out and replace it. You may have a bit of road kill lodged somewhere have you looked under the bonnet and...

Thanks john, I notice now the shed is up that there is ventilation around all four top edges where the roof fits. Because i will have radio gear in the shed i need it to be both warm and damp proof and wonder if i can block up most of these holes and just leave a couple with grills in for...

Hi all, Have been looking at ways to insulate my shed which will become my radio shack/ computer room. i hav e look at kingspan amd cellotex but these are quite expensive could i just use fiberglass loft insulation? cheers

thanks fred and richard c I was thinking of the mix fred :lol: paving slabs seems the way to go thanks again for your help guys :D steve

My wife as decided i would be better off if i took my radio shack come workshop in the shed :lol: so i have ordered a 12x10 shed which i intend to fit out as above. my question is what would be the best base to put this shed onto? it is going into a corner of the lawn and i was thinking of a...

Thanks for your reply :)

because i am fed up with mopping the floor as it is also a w.c :(

hi i have a wet floor shower and wish to fit a shower tray presumably i can use the wet floor waste outlet for the new trays outlet how should i do this ? meaning do i just poke the trays waste down the hole or make up a flange to take the new waste pipe? secondly and probably a more stupid...

senile it is thanks guys :) b

and 4.0mm ??

Hi all. In my dim and distant past i am convinced that you get a archtitrave sized drylining box am i right or just senile? dcwuk :)