Search results

Once again Softus, thank you for your reply. I have tested the system again: With the Aqualisa cartridge out and the pump on - cold gushes out, hot has a slow flow At the inlet to the pump - cold flow about 4 times greater than hot flow. At the surrey flange - hot flow to shower is...

Thank you for your reply Softus Am I right in saying that the hot and cold flows to the pump should be similar even though the hot water is coming through the surrey flange? My hot flow was significantly lower than the cold flow. Swapping the pipes over for the hot water and the shower is...

Hi there I have a power shower fitted and it has been working fine for many months. A few weeks ago there was poor flow of hot water. I was advised to change the Aqualisa grey cartridge, which unfortunately did not fix the problem. I was then advised to change the twin impeller pump...

Thanks guys! Your help is much appreciated.

I bought a pop-up waste unit to fit into the bathroom sink. I got the old one out and cleaned up the sink and fitted the new one with the new rubber seals. Problem - water drips out of the bottom seal and into the vanity unit!!! Do I need to apply any special substances to stop the leak...

Water is leaking down the back of the mixer taps through the sink hole that the taps fit in. I cannot tighten the brass nut up enough to prevent leakage. My taps are soldered in and I can lift them about 5mm. Should I squeeze some bathroom sealant underneath the taps before tightening the nut?