Search results

Hi all So I just replaced the inner and outer tie rods on my 2010 ford mondeo and after this i had 2 brand new tyres fitted along with tracking alignment getting done .. A few days after I notice a quiet clunk turning steering wheel side to side when stationery . There is no play in either wheel...

The battery on my 1.6 mondeo died and wouldn't start even with a jump start so I put the battery on it from my 3.0 v6 Mercedes-Benz. Im not using the Mercedes atm cos it needs some work so I figured use the battery off that for now until I source a replacement one for the mondeo The car...

Thanks guy I found it written on back of owners manual.. sorted now

As per title. Tia

How? So you can't just say if its not just the tracking or not ?

You can think that if u want but it ain't.. regardless waht is ur input about the situation ? Is it just the tracking you think?

Nope im serious... I had to cancel eirkung tonight at a restaurant delivering good cos of how bad the tracking it out and the tyres screeching.. is it normal for tracking to be this badly out ?

I have just replaced the inner and outer tie rods on my 2012 ford mondeo I had to put the spare wheel on the passenger side (17in idk why cos the wheels are 16 ) because the tire kept going down . So I started driving after putting it all back together and the tracking was way way out like...

Can I ask what could possibly happen if I drive without this 3ngine mount for 1 day

I mean mechanically is it likely to cause snu obvious damage if driven like this for 2 days

I mean the engine is still secured .. it will be until Wednesday that the motor mount will be sorted.. thanks

I had to remove the driver side engine mount timing belt side to do a different job .. however I didn't support the engine nad the engine has dropped down 2 or 3 inches .. I do not know where best jacking point under engine would be ti raise it a little so that I can realign engine mount . I...

Ill go car shop tomorrow see if I can get loctite I mean the new inner tie rods after I screw them on fingertips they dont seem to tighten anything more than one turn with a spanner after that every other turn seems to unwind .. I dont feel movement in and out on the new tie rods but i do...

Please see my above post.. and should I use loctite when installing new one? Thank you

Hi.. I finally got it off it turned out the driver side I had to push up on the spanner and the passenger side was push it down .. They were very tight but what I am concerned about is how they dont seem to tighten back up much at all .. Like after screwing it back on handtight and then I...

Hey guys.. I have a 2012 ford mondeo and im replacing the inner and outer tie rods.. I dont have the actual tool so using a 36 ml spanner that fits perfectly but it means i am doing the majority from the top unddr bonnet for good access although it meant removing a whole bunch of stuff from...