Search results

Most alarms have a “quick set” feature which allows a one button press to set. Then the system could be disarmed by a proximity keyfob which will require the keyfob to tap the keypad to disarm. Best systems with prox feature are Texecom Premier Elite (With seperate Prox Keypad LCDP or...

The smoke -we is a pile of crap. Made in Taiwan on behalf of Pyronix. Been replacing a few of them at work recently.

The elite platform is not discontinued just that particular variant of panel all W panels have been replaced with the 64-W. SmartCom requires V4 upwards, so either would be fine but 4.02 would be preferable. You won’t have any problems but may have to relearn all your wireless devices...

If your using Wi-Fi mode then the SmartCom has to be on your network first. Press & hold Wi-Fi button on SmartCom until Wi-Fi LED flashes slowly then search on your phone for the SmartCom wifi network enter the passphrase which is inside the SmartCom then open your phones web browser and enter...

It overwrites itself.

Reprogram, all devices in Area A then for example the landing detector needs to have the part1 omitted attribute active in the zone set up. Areas are mainly for commercial applications your after Part Arms. In your case all devices need to be in Area A ad you only have one area. But within...

Replace the PIR for a Dual-Tec Sensor, wire like for like.

Me too...

Doesn’t need an earth as it’s plastic. Just terminate the incoming flex with earth into the terminal block.

Yeah its a glitch in the software, when you exit it goes into 485 coms lost. Enter your user code and reset as usual. Later models don’t do this, it’s just the earlier ones.

I have a Hikvision wifi doorbell which works on the same app and also has an SD card. I can record it’s stream on my cctv NVR or view small clips via the app from the SD card so it may be the same for these cameras. In other words get a NVR and see if you can detect the cameras then you can...

in the 2000 menu there’s an option called backlight force no? You need to be in the keypad menu, not engineer menu or manager menu. Press and hold D for 5secs

Press and hold D wait til Panel asks for “security code” enter 2000. Press No until you get backlit option you can toggle on/off

Your welcome, glad you got it sorted.

Best to do on seperate zones as it’s easier to diagnose faults in the future. Take power from keypad as required

A link of wire across tamper terminals. Loop out the Tamp terminals near the zones and the Bell Tamper which will be a link across Ov and Tamp. How are your PIRs wires up? And what value resistors are you using?

If your wiring it EOL have you linked out the global Tamper terminals (Tamp) in the panel? I would suggest looping out all the tampers until it clears then add each Tamper one at a time.

A Two way wireless system would be ideal and shouldn’t cause false alarms as long as you follow the installation guidelines for the detector siteings. A Pyronix Enforcer would do the job and has a relatively simple setup. Fit a door contact on the final exit (front door) and program the exit...

What’s the signal strength like?

Does it ring if you Tamper it by taking lid off the siren? If not then it’s likely to be faulty. I think the piezo sounder plugs on to the module so make sure it’s plugged in correctly outside.