Search results

They were excellent. Thank you

Ah I get you put the bolt and nut in, in one go after the pan is in place. These fixings are usually ok then? I did think of throwing and using screws

Is like a bolt not much thread above so would have to get the height close to band on for the bolt to tighten

https://www.bes.co.uk/single-socket-bend-soil-vent-elbow-110mm-x-135-16120/ Like two of those put together. Does anyone no what size offset it makes

Think there official called single ended 45 socket bends

110 mm. Just 2 polypipe push fit single ended 45s

Thanks for all the advice. This is the basin

Thanks I don't have two fittings to push together sadly

Does anyone know roughly the pipe centre to centre measurement if you push 2 single ended 110mm 45s together. What size offset does it create.

.

Thanks I think there solid 6 inch breeze blocks

Thanks for finding that

Thanks just never fit one that heavy without a pedestal. It would be on a breeze block wall

I have some wastes.to run. I am doing 110mm in pushfit. And the 32mm and 40mm in solvent. What is best to connect to a boss/ the boss eye of a 110mm branch. Are the rubber ada

Thanks. I am wanting to go in to the eye of that in a horizontal water pipe run. With the 32mm pipe going in to it from above. Have always used the rubber connectors before but and thinking of going solvent

I want to boss into to the eye of a 110mm branch. If I use solvent am I best of with a solvent boss adapter to 40mm or can you still use the rubber ones? Thanks

I know have just swapped stuff before when trying to diagnose water hammer and then the noise has carried on

When they mentioned it before they did say it stopped when they opened a tap

Is it something a pressure reducing valve could cause. Like the diaphragm is bouncing up and down in it

Thanks. If stopped could be that