Search results

Hello, I've justed moved my Crabtree strarbreaker dual rcd consumer box by a couple of feet. I very carefully marked all the lives and am 100% positive that all the lives are back in the right place. However, I think I have made a mistake in assuming that all the neutrals can go any where...

Unfortunately, there is no flow gauges. It's a heat miser system - not sure if that helps. Based on the other response, perhaps I shodnt worry too much at it cyles. It's te just te fact that the flow e gets red hot straight away and te return takes a very long tie o heat up. The boiler is...

Sorry for terrible spelling on last message. Got one of these iPad things with some sort of auto correct on that I can't seem to switch off!!!!

Hi, the UFH system has its own pump. cannot remember the name but it's 15mm plastic outer flexy pipe with its own manifold / thermostatic valve etc. Approx 20 sq metres. It's simply teed of the main flow and returns on the main return right next to the boiler. I've lo put. Bypass in to try...

Hello. I've recently installed under floor heating in my house that is for the kitchen only. I've worked some smart electrics and have wired it so it can run completely independently, in other words when the central heating and hot water are off it will run through just the UFH circuit...

Thaks both for your replies. The trouble is - the pipework temperature ramp up can sometimes be so sudden (quick), despite turning the pipe stat back - it still has trouble controlling the overshoot due to the very slow response rate. I have tried winding the thermostat right back - but...

Hi, I've recently installed a pipe thermostat to my UFH circuit to help regulate the fluid temperature within the UFH sysytem. When the UFH is operating as a single circuit - in other words the CH + HW are off, the boiler sometimes beats the system at dissipating the heat which causes the...

Ah, Got you - thank you. I may have to accept I have to run it with the rest of the CH; which I suppose isnt too bad! Thanks again........

Hi, Thank you for the response, are you saying do away with the second pump I have installed PURELY for the under floor heating and then run the whole lot of just the one existing CH pump then? You say no flow from the boiler but, currently, I thought there would be flow from the boiler as...

Hi all, Literally just joined and to hopefully I can get some help with the following problem. I hope this will be a success! I believe this is possibly a common problem, but hopefully there is a standard solution? Ok, here goes. I have a one pipe system with a conventional boiler that...