Search results

Dont make them because there is no demand for them . Here is an elbow type . if you dont want to go with madrab idea https://www.bes.co.uk/pipe-tube-fittings/pipe-fittings/compression/compression-wallplate-elbow-22mm-x-3-4in-17717/

No it wont clear sludge you need x400 first then once flushed you add x100 . X200 is a silencer and will quieten noisy boilers

on both then initially change the main sensor in the dry pocket

DO NOT TOUCH the isolating valves unless you want a very high chance of them leaking Plenty of room ? there is about 6 inches of pipe on show

yeah venturis fall apart usually show up first on thermostatic showers , Tip to get all the bits out tape a bit of hose pipe to your hoover hose and quick switch on gets all the bits out

only ever had the lead to a 105 gas valve faulty once and that was about 20 years ago there is diodes in it seemingly , yep a strange one

what temp is your cylinder stat set to because if its too high cavitation can occur in the shower pump So keep it below 60 degrees

Worth checking for a neutral fault to

certainly a head scratcher

long shot Have a look at the condense trap there is two wires on top of it pull the one at front off see if it fires up .

i wouldnt bother then

very strange fault Was it a brand new pcb or reconditioned and definitely not an instant pcb by mistake . Earth wires from and to pcb re connected /altered Correct wires put back on sensors / red to ch sensor green to hw sensor Has anything else been done to boiler ? Polarity well worth a check

Do all your rads heat up with no cold spots

when you say nothing happens when hot water runs . do you mean no demand light comes on and it doesnt fire ? Does the pin come out and hit the microswitch

105 instant ?

i have given you the charts given/given you the online calculators and the figures that agree with what i put . I told you to read what the original poster said they had and to stop making up in your own mind what they have and waffling away talking shyte . I am not here to educate you its...

i would go 120 to 130 but unless got them to hand its guess work depending on length of male part

two flashing lights on a 105 is a new board required 99% of the time . No the rad water cannot mix with the water coming out the shower she must be smelling the drains or something else

it all depends how long the male bit is that goes into the female socket More information required on what it is that is 110mm

Why are you speaking to yourself ? first sign of madness . I would go as far as saying you are round the pulled bend so from now on i will just give you the elbow