Search results

RRRRRR UUUUU taking the ****SSSSSSSSSSSSSSS

Boiler wiring is so simple. A switch tells a boiler in needs heat. The switch is a time clock or a thermostat. The switch or thermostat turns on a motorised valve which switches the feed to the boiler. The boiler turns on, on demand. It may need a permanent feed so it runs on, to...

OK WELL, OK WELL, OK WELL, OK WELL It sounds like you could have a split board and the neutral is on the wrong side. Is it the RCD that trips? Try changing the neutral At the bottom right of this box there is a "Spell Check". Use it OK WELL, OK WELL, OK WELL, OK WELL

Coljack Can you please explain "is it not allowed to install an earth rod if you have a TN system?"

With a 30mA RCD the ELI could be up to 1666 ohms, although NICEIC have suggested the 200 ohm figure. You need to establish what the correct figure is

What test equipment do you have? What is Ze and what is the PSCC? They are important, for reasons you will not understand! Is main earth and bonds up to requirements? As previously indicated, you need proffessional advise

"1000Watt, Power supplies" just over 4.5 amps Without beating about the bush, you need proffessional advice, as you don't have a clue. Employ an electrician

What was the reading ? Is it a 30mA RCD fitted. Where was the white goods man from?

Cordless phone ???

Nusku You did fit the starters?

Sub-contract the job to RF Lighting as they no all the answers! :wink: :wink: :lol: :lol:

You leave it on for 30 minutes and then feel the transformer :lol: :lol:

Switch 1 off Switch 2 On for 30 secs. and then off Switch 3 On If lamp not on then switch 1 If lamp off but warm switch 2 If lamp on switch 3

Great reply Secure A picture paints a 1000 words

[/url] Agreed - Well nearly Ben Has any testing been carried out? Ze from other end of pyro's? Is this also "Large Victorian house is split into 4 flats."?

[b] Jim Go into an electrical wholesalers and ask to see bare MICC. Ask to see a gland pack which will come with a pot and a stuffing type brass gland. Ive made off 100s of pyro ends and what you see is what it is, a pyro end You are spot on with your last sentence. Leave well alone...

How old do you think this installation is? Common practice in these days.

NO. Came in coils and you cut to length and put pot on which is what you see. Would be terminated into a junction box either with a gland or a box fitted with specific clamps. Copper clips have been used in the case you have shown.

JohnD Your pulling our leg.- Are you? Its good old MICC. Many years ago there was a shortage of pvc type cable and MICC was used quite extensively

NACOSS changed years ago. Now NSI, National Security Inspectorate. Still does not alter the fact its shoddy workmanship